So question I have heard that ohmic is very temperamental and can have slag from piercing cause it to not read the plate? or dirty material cause it to not read... so with that I find a floating head better in some situations.
I heard that too, and if you have too much water on the table it can also impede your cuts. I have the floating head and has worked fine. But Jim knows best.
This guy is a wealth of knowledge
So question I have heard that ohmic is very temperamental and can have slag from piercing cause it to not read the plate? or dirty material cause it to not read... so with that I find a floating head better in some situations.
I heard that too, and if you have too much water on the table it can also impede your cuts. I have the floating head and has worked fine. But Jim knows best.
does probing use arc voltage sensor? if true, is it necessary to change the post processor on sheetcam
Доброго дня. Не знаете ли Вы, есть ли подобная система контроля высоты инструмента в фрезеро-гравировальных станках?
😊 شرح رائع