Writing on a curved surface (extruding and engraving letters) using PTC Creo parametric

[@mohannadismael178]

رغم اني شهدت هذه المحاضرة قبل عدة سنوات في لاب الجامعه لكن مرت السنوات وها انا اتعلم منها مره اخرى لكن هذه المره في ميدان العمل بارك الله في علمك دكتورنا الفاضل دائما مناره لطلابك

[@knowledge-corner]

حفظك الله يا مهند واسال الله لك التوفيق حيثما انت

[@azeemsaifi3212]

Bahtreen 🤩😍🙊 Cammand Cero Parametric 🤘🤘👍

[@nafizascookinghouse9722]

Nice sharing

[@vineeth9295]

Sir it was a good tutorial thank you for that. And without wrapping step also I was able to extrude from the curved surface.

[@knowledge-corner]

Thank you for the constructive feedback. I did not try your method to check the difference. However, you could do it successfully in your way. Keep up with the good job.

[@vineeth9295]

@@knowledge-corner thank you sir

[@AtomicJerk84]

0:38 Process starts.

[@UTalkIndia53]

Good contents

[@knowledge-corner]

Thanks a lot 🌹

[@deepakjohn9273]

THIS VDEO IS VERY HELPFULL THANK YOU

[@knowledge-corner]

Glad it helped

[@sathish8068]

how to colors change only extrude or engraving letters...???

[@juicerfan2084]

Thanks, it helps, may I know how to cover the whole curved surface

[@knowledge-corner]

Sorry for my late reply, since I was away for some time. Could you please clarify your question?

[@juicerfan2084]

@@knowledge-corner Thanks for your reply, I just want to know how to make the text surround the entire cylinder, including the back of the cylinder. I tried some methods, but the words only cover the surface infront of me.

[@atulprajapati58]

Len Mark 3Ds laser engraving software ki knowledge mil sakti h sir....

[@knowledge-corner]

Thank you for contacting me. Could you please write your inquiry in English so I can help you?
Thanks

[@dargue2021]

what song is this?

[@knowledge-corner]

Thank you! I used the free sound library in RUclips. However, I will check the song and tell you 👍

[@gilbertgoldbaum2658]

tellement compliqué et non instinctif