One more tip for those who bother to scroll down and give the video a like or write a comment ... I really appreciate it ... So the tip is, afterwards don't forget to hang your " Sound Deadening Pad " back once you are done. If you don't want the " WOoooong " when you close the door , you're welcome 🫡 😄 👍
I find the easiest way is to screw the bolt in from the inside, and just tighten it until it just touches the door. And then tighten very lightly, so that you can move the door up and down with minimum force. Then close the door carefully" be careful not to hit the fender" once the door is closed and then look at the seams, open the door halfway and slide it up and down to the position you want and check again, a video about this will seem a bit boring, this is fitting work, and it is a lot of opening and closing until you get the desired result. good luck and be patient :)
One more tip for those who bother to scroll down and give the video a like or write a comment ... I really appreciate it ... So the tip is, afterwards don't forget to hang your " Sound Deadening Pad " back once you are done. If you don't want the " WOoooong " when you close the door , you're welcome 🫡 😄 👍
Good stuff as always buddy. The attention to detail is great, I bet this will help many DIYers.
insanely satisfying work! Love to see an old BMW restored the right way. There must be a big future for this channel!
Thanks ! 🙂
Great quality vid as always, explained so even dummies like me can understand 😅
Thanks! 😁
Beautiful job and great instructions regarding the process. Thanks so much!
Well done on the door and great job on the video!
Zoals altijd, mooi werk!
Very very nice work. I wish you would have shown if you adjusted the door gaps after you put the doors on.
I find the easiest way is to screw the bolt in from the inside, and just tighten it until it just touches the door. And then tighten very lightly, so that you can move the door up and down with minimum force. Then close the door carefully" be careful not to hit the fender" once the door is closed and then look at the seams, open the door halfway and slide it up and down to the position you want and check again, a video about this will seem a bit boring, this is fitting work, and it is a lot of opening and closing until you get the desired result. good luck and be patient :)
@@Restorezone Thanks much for your reply. Keep up the good work. Subscribed.
Great work, thanks for sharing!!!👍👍👍
Very nice job! Love too see it! 😊
Love ur videos, hope I will some day repair my own 2002
Thank you ! I hope the same for you 🙏🙌🙂 ...
C'est vraiment du super boulot !
Merci! 🙂
Great job, I have holes in my outside skins in both sides and wasn’t sure if this was a job I could do. I think it is though 🤘
thanks , and I say good luck , for when you start ;) will be fine
Nice work!!! I’ll be DIY restoring several of my 02s soon @carsandwhisky