Great helpful video with lots of tips, two bits of advice when taking out the old wing mirror tie a piece of string to the old electrical connector so you can use it to thread around the new electric connector and use it to pull it back into position, also take out the three screws that hold the speaker in it's position by this means you can use your hand to put the electrical connector through the correct hole as it's quite tight, once again many thanks for video, much appreciated.
Don’t go through the square cuts on the door corner, there’s a gap between the two square cuts and the door panel, feed the cable through the gap and then through door square plugging it with the rubber stopper
Great helpful video with lots of tips, two bits of advice when taking out the old wing mirror tie a piece of string to the old electrical connector so you can use it to thread around the new electric connector and use it to pull it back into position, also take out the three screws that hold the speaker in it's position by this means you can use your hand to put the electrical connector through the correct hole as it's quite tight, once again many thanks for video, much appreciated.
Glad I could help
Its more easy when u can use 2 hands ,and not record what u r doing
But nice tips
How do you get the panel off those plastic holders after it's unscrewed? They're inaccessible and a pain.
Just pull off
There is a bit of glue holding the black panel
You can also unscrew the speakers to put the cable through easier
That could help
Thank you!
Glad i could help!
I followed these instructions but the wire blocked the window moving up and down. What an I missing? Thanks.
There is a clip on the wire,that holds in together with the door
On the inside metal, so the wire is not loose
Don’t go through the square cuts on the door corner, there’s a gap between the two square cuts and the door panel, feed the cable through the gap and then through door square plugging it with the rubber stopper
Great info thank you 👍
Glad i could help!
Awesome
🤘