Line Heater for Plastic Sheet Bending AUS NZL

Techspan Group
Australia: www.techspan.com.au
New Zealand: www.techspan.co.nz
Our SF range of Hot Wire Strip Heaters provides maximum flexibility, fast setup and quick and efficient heating. Supplied in working lengths of 600, 1000, 1500 and 2000mm, machines can be fitted with up to four heating beams. Modules are kept in stock for quick delivery of machines tailored to your requirements.
Heater beams are only 30mm wide, allowing close-centre bends to be produced with ease. Heater beams are fitted with twin wires for fast heating of materials up to 6mm in thickness. Calibrated adjustments ensure easy and repeatable setup. Different combinations of wire spacings, heights and wire power can be used to produce the best results on most materials.
Techspan Group
Australia: www.techspan.com.au
New Zealand: www.techspan.co.nz

[@billusingh6234]

Fine machine thanks 👍

[@capnjunke]

what type of plastic is this?

[@MudMotorsMax]

That Was some sort of polyethylene such as low density or high density. It can definitely be shaped and bent since it’s a thermoplastic Especially if the sheets or not to too thick

[@vishwam1769]

Is this PP?

[@MudMotorsMax]

That was PE polyethylene Either low density or high density

[@damonbusby6442]

Do you know of anything that will work on bending half inch hdpe?

[@TECHSPANONLINE]

what thickness do you need to bend ? is it sheet ?

[@damonbusby6442]

@@TECHSPANONLINE it is half inch sheet hdpe

[@TECHSPANONLINE]

@@damonbusby6442 8mm - 10mm thickness.. just on the edge of moving to an extruder welder..