@@bobbydee5195 ive done some videos on it already, such as the wheel speed sensor set up which is probably the hardest part, what else might you be struggling with?
@2slow2stroke tbh, I've never wired any additional parts to a scooter before, so all of it tbh. How to wire it to the ignition would be an interesting watch.
@@bobbydee5195 the issue is Ive already done the work, and cant undo it to re-do, Ill have to maybe do something similar, but all I did was cut the ignition wire into 2 pieces, put one of the ignition wires with the gauges ignition wire (which will be shown in the instructions) and the slip a piece of heat shrink either over those 2 wires or the 1 remaining half of the scooter ignition wire, then twist all three pieces of copper wire together nice and tight and solder them, then you can slide the heatshrink back up to the solder point fully cover the solder and any copper wire, and thats it, its pretty easy really bud
@@paulflood4420 hold the 2 buttons down on the gauge for about 5 seconds, then just keep cycling through the menus till you get to wheel speed sensor section, you can tell it how many magnets you have and the wheel diameter, the gauge should of come with an instruction manual, if it didnt you can view it online at www.pedparts.co.uk/product/702/stage6-digital-speedo-clocks-rev-counter, scroll down to instructions
looks good
Hey 👋 could you do a video on fitting and setting up the stage 6 digital dash?
@@bobbydee5195 ive done some videos on it already, such as the wheel speed sensor set up which is probably the hardest part, what else might you be struggling with?
@2slow2stroke tbh, I've never wired any additional parts to a scooter before, so all of it tbh. How to wire it to the ignition would be an interesting watch.
@@bobbydee5195 the issue is Ive already done the work, and cant undo it to re-do, Ill have to maybe do something similar, but all I did was cut the ignition wire into 2 pieces, put one of the ignition wires with the gauges ignition wire (which will be shown in the instructions) and the slip a piece of heat shrink either over those 2 wires or the 1 remaining half of the scooter ignition wire, then twist all three pieces of copper wire together nice and tight and solder them, then you can slide the heatshrink back up to the solder point fully cover the solder and any copper wire, and thats it, its pretty easy really bud
How do I set the setting for the wheel
@@paulflood4420 hold the 2 buttons down on the gauge for about 5 seconds, then just keep cycling through the menus till you get to wheel speed sensor section, you can tell it how many magnets you have and the wheel diameter, the gauge should of come with an instruction manual, if it didnt you can view it online at www.pedparts.co.uk/product/702/stage6-digital-speedo-clocks-rev-counter, scroll down to instructions