Thanks for the video. I have the same 4 wheeler I’m restoring and limited content online for this repair. For the right axle bearing and dust seal, do you have any additional views of how that goes together?? Seal and bearings my quad was completely gone and not sure which bearing should go there??
Good video overall. I'm working on my 98 BB now. Question I have is how in the world did you gwt the two locking nuts off the axle? Are the reverse thread? I've heated them up with a torch, only managed to melt the dust cap. Pulled so hard in turned the front wheels. Any suggestions? Thanks in advance.
Enjoy your videos I have a 1999 big bear, 350, 4x The rear main seal was leaking. I removed the rear end, swing arm, u joint and replaced the seal...went good, just no fun doing it by myself in cold barn. All back together, worked fine for bout 10 hours Then started doing same thing. All the oil leaked out into the rubber boot and out the engine. Kinda strange that it seem to leak, both times while cooling, not while running??? At least that's when i noticed it. Any ideas? Seal seemed to be good when i replaced it, haven't done it the second time yet. Obviously, something else is wrong. Help?
Not sure make sure there are no rough spots where seal rides and I also use a sealer around the outside of the seals also for added protection thanks for watching and good luck with it
At one point , 3:30, I thought I heard you say
manamna. do do Doo.
Good info thanks 👍
Thanks for the video. I have the same 4 wheeler I’m restoring and limited content online for this repair. For the right axle bearing and dust seal, do you have any additional views of how that goes together?? Seal and bearings my quad was completely gone and not sure which bearing should go there??
Sorry that is all the video I had of that your best bet would be a repair manual well worth the money especially for a restore thanks for watching
Is there a way to make this axel work with a chain …im trying to put a dif engune on it and was wondering if theres a way to make it work wit a chain
I got the lock nuts off how does the axle come out? Please help.
Good video overall. I'm working on my 98 BB now. Question I have is how in the world did you gwt the two locking nuts off the axle? Are the reverse thread? I've heated them up with a torch, only managed to melt the dust cap. Pulled so hard in turned the front wheels. Any suggestions? Thanks in advance.
I used a air chisel
Enjoy your videos I have a 1999 big bear, 350, 4x The rear main seal was leaking. I removed the rear end, swing arm, u joint and replaced the seal...went good, just no fun doing it by myself in cold barn. All back together, worked fine for bout 10 hours Then started doing same thing. All the oil leaked out into the rubber boot and out the engine. Kinda strange that it seem to leak, both times while cooling, not while running??? At least that's when i noticed it. Any ideas? Seal seemed to be good when i replaced it, haven't done it the second time yet. Obviously, something else is wrong. Help?
Not sure make sure there are no rough spots where seal rides and I also use a sealer around the outside of the seals also for added protection thanks for watching and good luck with it
You this be pretty much the same for a yamaha dx225 3 wheeler?
How do you remove the nut that goes threw the top of the swing arm on both sides that connects to the bike
It’s not one bolt each side is separate loosen nut then unscrew Allen bolt on each side
Am si eu 25o e 4x4 si am nevoie de partea din spate complecta cu diferential cu tot ...cat costa .???Marian Romania.
It cost me about $65 at the time I think. thanks for watching
What's the bearing kit part number
eBay item # I used 283820484895