How to replace an inside Sub Panel, with trade installation tips

In this video I show how to replace a subpanel that is inside the house in drywall. The bussing on this panel went bad due to a loose connection on the neutral bus bar. I also had to pull a few circuits in the attic and put them into a junction box and run new wire, because it had burnt due to the bussing failure and there wasn't enough wire to cut it back to clean wire.
The content in this video is in no way to be substituted for advice from a licensed Electrician/Engineer/AHJ in your State and municipality. For exact and complete details consult a licensed Electrician/Engineer/AHJ that works with the local jurisdiction in your area. Never disregard professional information based off information you have seen or read in this content. It is also does not give consent, permission, or advise you to complete anything shown in the video.
Warning: Perform at your own risk. Only perform if you are a qualified Electrician. If you are not, contact a licensed Electrical contractor to complete your project.
If you have any questions you can email me at [e-mail]