2019 Honda Odyssey Evap Canister Replacement

[@kamandor]

Very helpful. I just replaced my fuel Vapor canister and suggest the following for anyone else:
1. Jack up the drivers side as high as you can. Get a jack stand under the lower control arm.
2. Remove the rear drivers side wheel, as this will give you more space to move around / lay on your back.
3. Wear safety goggles. The three 10mm bolts will likely be a bit rusty and will drop debris.
4. There are a total of 5 connectors / clips to disconnect. The fifth one is on the “top” closest to the vehicle and is a wire that passes just over top the two connectors closest to the side of the vehicle.
5. Depending on the replacement canister you get, you may need to reuse the mounting bracket that clips to the inner side of the canister (closer to the middle of the vehicle.) I had to reuse the existing bracket as my replacement unit didn’t come with it.
7. Like in the video, put the van in accessory mode, then clear the code, then start it and drive it. Should clear the code for good. Good luck! 👍🏻👍🏻👍🏻

[@asianmechanicguy6483]

thank you

[@stevensantiago746]

Great job👍🏽 Thanks for video

[@asianmechanicguy6483]

Thanks for watching!