1416.05g. Woohoo...first try on a Tier 5 part! About an hour. Fun part was the revolve cut extrude to remove the conic shape at the end. These practice models are so much fun--thanks, Toby!
1416.058 g done in freecad. very anti boring model 🙂 took far to long. basic model was more or less quickly build, but getting all this measurements right and seeing all the details was definitely a challenge.
I'm new to SW. How do you do get the extrude next to a round face without a zero geometry error? The circular parts were simple, but attaching the other part to it gave me some trouble.
Here's a LIVE SOLVE of that model - I did it using Onshape but the 2 programs are close enough that I think you'll be able to use this guide to figure out how to model it in SW: ruclips.net/user/livea-TV9nlEjsQ?si=EBYDPVht-Qt5r1IN&t=2373 Good luck! If you're still stuck after this, hit up the discord (link at www.TooTallToby.com/practice) for questions - great crew in there!
1416.05g. Woohoo...first try on a Tier 5 part! About an hour. Fun part was the revolve cut extrude to remove the conic shape at the end. These practice models are so much fun--thanks, Toby!
Awww yeah nice job!!!
1416.058 g done in freecad. very anti boring model 🙂 took far to long. basic model was more or less quickly build, but getting all this measurements right and seeing all the details was definitely a challenge.
Very nice!! Glad you enjoyed this one! here's my walkthrough in Onshape: ruclips.net/video/uH8UAAe98PA/видео.htmlsi=KGKYKzCN6G377eH_
SW 1415.10gm 13:10 min used three features extrude , extrude cut , revolve cut
Awww yeah well done!
1418 g in 68 minutes! good golly that part was difficult for me. Thought there were several dimensions missing.
lol - that one is a cool part but yeah - tricky!!
ran out of time on that one, had to pause it for bout a minute haha. 1416g
awesome!
Great model Toby. Lots of tricky bits in there... 10:22 min
Awww yeah glad you liked this one Steve!
SW @ 10:10min. 1416.057 g Struggled a bit but always Fully Defined
Awww yeah nice job!
I'm new to SW. How do you do get the extrude next to a round face without a zero geometry error? The circular parts were simple, but attaching the other part to it gave me some trouble.
Here's a LIVE SOLVE of that model - I did it using Onshape but the 2 programs are close enough that I think you'll be able to use this guide to figure out how to model it in SW:
ruclips.net/user/livea-TV9nlEjsQ?si=EBYDPVht-Qt5r1IN&t=2373
Good luck!
If you're still stuck after this, hit up the discord (link at www.TooTallToby.com/practice) for questions - great crew in there!
1416.06 in 13:14min, Solidworks 2024, 6 features. Two different mistakes to get correct answer, not my best work
nice job figuring it out though!
SW2024
1416.05 g
9:44
Nice Amir!
1416.06 g 9 min to do it . Dragos
awww yeah
1416,06 in 9:24
nice will - speedy!