The purple cable runs straight from the compressor to the switch. then I ran power and ground to the switch. I believe the compressor has a built in relay. It gets wired directly to the battery, so no need to run a relay on the switch cable.
Great install video just got this setup for my 2007 v8 4runner my bracket is a M.O.R.E. Bracket That also months the 1 gallon arb Tank as well I'm installing the Inflation kit and the lockers also though
Thanks. That is also a great setup that I considered. In the end I decided against the 1G air tank and wanted a bit more clearance above the compressor. Thanks for the comment.
I am using the manifold to preserve my air hose. At times i use the compressor to fill up multiple vehicles in a row, which could cause enough heat to break a plastic hose.
I used it on the wire that runs from the power source to the switch. It only allows the current to flow in one direction. As it was included in the harness I assumed it may be necessary, so I made sure to include it in my configuration.
Got an issue with my ARB dual compressor. The fuse keep in burning.
Can you show how you wired your switch up? Did you run the purple cable to a relay?
The purple cable runs straight from the compressor to the switch. then I ran power and ground to the switch. I believe the compressor has a built in relay. It gets wired directly to the battery, so no need to run a relay on the switch cable.
thank you! @@offroadyotaxploration
Nice install!
Thank you!
Great install video just got this setup for my 2007 v8 4runner my bracket is a M.O.R.E. Bracket That also months the 1 gallon arb Tank as well I'm installing the Inflation kit and the lockers also though
Thanks. That is also a great setup that I considered. In the end I decided against the 1G air tank and wanted a bit more clearance above the compressor. Thanks for the comment.
@@offroadyotaxploration yvw good video
Is the manifold required?
No, you can run the hose straight to the compressor. If the compressor runs for a long time though, the hose will get quite hot.
So are you using the manifold simply for convenience? @@offroadyotaxploration
I am using the manifold to preserve my air hose. At times i use the compressor to fill up multiple vehicles in a row, which could cause enough heat to break a plastic hose.
what was with the diode?
I used it on the wire that runs from the power source to the switch. It only allows the current to flow in one direction. As it was included in the harness I assumed it may be necessary, so I made sure to include it in my configuration.
Ok good deal
👍
Thank you