THANK YOU! Seriously I am thinking of making it myself what you depicted here. This makes so much sense - I am looking into front / rear stand for my motorcycle (weights ~850lbs) and some of good quality run into ~$600-700 plus (excluding shipping)
@@namoothewoodprojectsMy bad! I did the math wrong, the three 1.5” flats stacked would only be 4.5” total, the width only matters for how high you want it lifted after you rotate the stand. I edited my above comment for correct dimensions.
THANK YOU!
Seriously I am thinking of making it myself what you depicted here.
This makes so much sense - I am looking into front / rear stand for my motorcycle (weights ~850lbs) and some of good quality run into ~$600-700 plus (excluding shipping)
came for the lift. Stayed for the crocs 🐊
Fell in love with Ryobi
What kind of screws?
I used 2-1/2 inch screws!
Nice but my question is about fat boy’s ground clearance? It Is only 5in from ground and you use 3 pieces 2in each?
Thanks anyway for sharing
I forgot the numbers but I had to cut the wood narrower because it was too wide. You know, Bike just need to be few inches in the air
Dimensional lumber (like what you’d get at Home Depot, etc) 2x8 is actually 1.5” x 7.25”, so three of them stacked like that would only be 4 1/2”.
I think it was 2x8 and I had to cut it a bit narrower like 6.5” or something like that. And nope I didn’t use planer to make it thinner
@@namoothewoodprojectsMy bad! I did the math wrong, the three 1.5” flats stacked would only be 4.5” total, the width only matters for how high you want it lifted after you rotate the stand. I edited my above comment for correct dimensions.
Perfect! Thank you.
Do you know you have crocks on? I gave you the 👍🏼 regardless. Lol
Crocks are back in, mine are crock copies from Lidl, they make great summer slippers.
👍👍😁
They make winter slippers too. I have one and VERY warm
@@peroduanippa back in? They never went out!
Crocs are where it’s at!!
are the length of the cut wood?
It’s been awhile. I don’t remember correct numbers but i think it’s about 35 inches long
That works for me!!!👍
Great 👍 👌
Is it high enough to remove the wheels
I haven’t removed wheels but I think you’ll need more clearance to do the job
What size is the wood 2x8 or 2x10??
2x10 :)
great idea
❤
Nice👍👍👍👍
Ok no drive bike~
Not until next February ❄
SO CHEAP!!! LOL...
Not wasting my time where the content creator is either unwilling or unable to speak and articulate their process.
Well you did comment on the video so you did waste your time. No words were necessary, this video gave me the info I needed to build a bike jack
$30,000.00 bike and a $15 Stand, ya, no thank you
❤❤❤
Whatever works I guess. 🫤