This was a very informative video. I had always wondered what it would be like to help a calm, soft-spoken dad, and the wet kit information was nice too.😜
This video is awesome! I never fully understood how a pto is connected but you made it all perfectly clear! Thank you very much for making the video!!!!
Out of curiosity, why not keep the fuel tank and add a hydraulic tank up on the catwalk? Or is there room to mount it in between the frame under the catwalk?
My neighbor is having this installed on his truck. I’m building all the hydraulic lines for it. So my question is are your crimp fittings going to and from the pump JIC, Males O-Ring Boss, Male Pipe, Flat Face Seal?
This was a very informative video. I had always wondered what it would be like to help a calm, soft-spoken dad, and the wet kit information was nice too.😜
Good video check backslash before tightening the pto bolts forgot to check when tight I would check it after been installed
This is a great detail video of PTO installation. Thank you.
This video is awesome! I never fully understood how a pto is connected but you made it all perfectly clear! Thank you very much for making the video!!!!
Out of curiosity, why not keep the fuel tank and add a hydraulic tank up on the catwalk? Or is there room to mount it in between the frame under the catwalk?
Did you have to do any reprogramming for the 12 speed? Has the transmisson thrown any fault codes since installing?
My 2021 579 set up the same
hello where did you buy that bracket for the filter and the coupler mount?
Thanks for this video
That bracket and drain fitting is called an anti spin kit. Kenworth tanks are notorious for rotating and that is their solution.
anyway to speed up dump action and when you lower the box? without reving the engine up?
Hi great video. Question: can the RETURN hose be half way into the tank or does it have to be at very bottom of it ?
thank you.
Hi
I have a question Eaton still covering your transmission warranty if you installed pto wet kit
My neighbor is having this installed on his truck. I’m building all the hydraulic lines for it. So my question is are your crimp fittings going to and from the pump JIC, Males O-Ring Boss, Male Pipe, Flat Face Seal?
So the crimp fittings are only for the suction hose, all pressure lines need to be JIC.
was it a noisy engage
What's the part number for that pto?
Want to install pto on my DT12 transmission
How am I able to do that?
What trailer is that!?