any tips for heating the board up? i have a hot air station and saw you said 450* and that you went from the bbottem but any tips for it would be appreciated
If not have a hot air station I used a metal rod not a huge one tiny and heated the end of it with a torch lighter and stuck to the four spots one at a time careful barely hit it with the rod.
Smh man this is pure bs… I didn’t know you’ll need all that extra crap I thought you unscrew and replace. You gotta melt shit then add glue? What is that stuff where do you get maaan smh I should have took this shit to the shop 😭😭😭😭😭😭😭😭😭😭!!!!!!!!
Well done, I liked your video - thanks for taking the time to post it. What microscope are you using if you don't mind me asking?
Thanks!!! I appreciate it. It’s a AMScope
any tips for heating the board up? i have a hot air station and saw you said 450* and that you went from the bbottem but any tips for it would be appreciated
Hey 450-500C should be good, no tip on the nozzle as well, and air flow around 70 should do the trick. Also put flux on the pins before heating.
@ I have a dial from 0-6 lol, I probably will put a bigger nozzle to increase air flow a bit but I’ll see,
What did u use to remove it?
Hot air station
If not have a hot air station I used a metal rod not a huge one tiny and heated the end of it with a torch lighter and stuck to the four spots one at a time careful barely hit it with the rod.
You need a heat gun, 450-500 degrees Celsius.
Smh man this is pure bs… I didn’t know you’ll need all that extra crap I thought you unscrew and replace. You gotta melt shit then add glue? What is that stuff where do you get maaan smh I should have took this shit to the shop 😭😭😭😭😭😭😭😭😭😭!!!!!!!!
definitely not as easy as people make it out to be, and you also need the equipment/tools