The off position should be on the neutral position of the trigger ( center) , so what you do is (after binding is done), switch on the TX, pull trigger fully (don't let go) , connect esc to batt, wait for two beeps, and let go to neutral position, wait for the rest of beeps, its done.
I follow u setup its easy to program tq sir 🎊🎊
Hi i followed your instructions and set up was easy.
The off position should be on the neutral position of the trigger ( center) , so what you do is (after binding is done), switch on the TX, pull trigger fully (don't let go) , connect esc to batt, wait for two beeps, and let go to neutral position, wait for the rest of beeps, its done.
Can you make the motor rotate only by using that Wi-Fi module connected to the app, without the receiver and controller?
DOES THIS PROGRAMMER CAN SET LOW VOLTAGE DISCHARGE LIMIT FOR BATTERIES OF 36V-48V ??? BIG THANK YOU
could i use this to start the motor without remote, for testing motor?
can you reset esc without the programme box?
What size WIRES are on the 90A ? also, where did you get the Program Box from ? THANKS
That's good!
forward e reverse ( Bidirectional )
When pushing the throttle inti reverse sem card. Apenas transmitter
Bang pake bahasa indonesia aja
А карта с ним идет
good job mate thanks