NC Studio re-start midway in the G-code after a power cut disaster How to

[@jawadiftikhar3387]

Good job dear

[@rogerwebb9600]

Thank you so much

[@Jhone888]

😮 thank you thank you 👍👍👍👍 ❤❤❤

[@Cocobolomasine]

Sir, any advice my NC studio after program finished won't turn off spindle, how to fix that?

[@antoniorojas4015]

WHY I CAN NOT TO LOAD FILES INDIVIDUALLY AT MY CNC STUDIO? WHAT KIND OF FILES SHOULD I HAVE TO HANDLE?

[@rogerwebb9600]

Hi, you need to use Gcode mm (Tap) or Gcode inch (Tap) files
Carveco Maker will generate them for you.
My CARVECO/ArtCAM 5% discount code is
ROGERWEBB5798
(ONLY AT THIS ADDRESS BELOW)
store-us.carveco.com/collections/roger-webb-discounted-products
store-us.carveco.com/?ref=B40mt_z8N7xiu

[@valcirhihlmann830]

OK MUITO BOM

[@samehabdulhamid9977]

❤❤❤❤❤❤❤❤❤❤❤❤❤