I used this video to replace PIR lens on Recon Force Extreme. 1. Phillips screwdriver size is 3 mm (Sets with tweezers, pick, magnitized ends, etc., cost around $10.00) 2. In my Cam the 1st screws you removed were deep set & covered with soft plastic (for protection from moisture). I had to bend a large safety pin at tip to remove it. 3. My Cam did not have outside screw below screen. Everything else just like yours. PIR lens replaced.
Great video, thank you. Unsuccessful so far however - the 6 screws are ridiculously tight. Only have jewelers tools sized phillips (no standard handled phillips screwdrivers narrow enough to fit in the holes) , and not near enough torque on those tiny tools to break the screws loose - and of course ferarful of stripping them. Ugh
I used this video to replace PIR lens on Recon Force Extreme.
1. Phillips screwdriver size is 3 mm (Sets with tweezers, pick, magnitized ends, etc., cost around $10.00)
2. In my Cam the 1st screws you removed were deep set & covered with soft plastic (for protection from moisture). I had to bend a large safety pin at tip to remove it.
3. My Cam did not have outside screw below screen. Everything else just like yours. PIR lens replaced.
Great video, thank you. Unsuccessful so far however - the 6 screws are ridiculously tight. Only have jewelers tools sized phillips (no standard handled phillips screwdrivers narrow enough to fit in the holes) , and not near enough torque on those tiny tools to break the screws loose - and of course ferarful of stripping them. Ugh
You know what they say about guys with small hands?