Размер видео: 1280 X 720853 X 480640 X 360
Показать панель управления
Автовоспроизведение
Автоповтор
What about alignment? Do I have to do 3-2-1 , etc.as in classic 3D inspection?
Thus upper limit and lower limit are same value of tolerance
What if we need to change inches vs mm?
When you select program from the main screen, you will get a drop down menu in the top corner. Select settings - display settings and you can change the units.
Can this system take images?
Yes - I believe you can take images of what gets displayed on the output screen and save them to the machine or network drive.
Should position the camera square to the computer screen . You are at a 45 degree angle. The right side of display screen is hard to read .
Thanks for the feedback, we will keep that in mind on the next set of videos.
What about alignment? Do I have to do 3-2-1 , etc.as in classic 3D inspection?
Thus upper limit and lower limit are same value of tolerance
What if we need to change inches vs mm?
When you select program from the main screen, you will get a drop down menu in the top corner. Select settings - display settings and you can change the units.
Can this system take images?
Yes - I believe you can take images of what gets displayed on the output screen and save them to the machine or network drive.
Should position the camera square to the computer screen . You are at a 45 degree angle. The right side of display screen is hard to read .
Thanks for the feedback, we will keep that in mind on the next set of videos.