I just did one on a 2004 Honda Accord 2.4L. This video was a big help on what I was about to get into. There is only two ways to do it, drop the frame or pull the whole engine with the tranny together from top. I dropped the frame. The rack and pinion can stay on the frame just disconnect the high pressure hose from the pump and the rubber hose portion of the low pressure return. Remove front and rear motor mounts, A- arms, drive shafts exhaust down pipe, starter and transmission lines. Then you are clear. If I was to ever do it again, I would take the engine and tranny out the top.
Can anyone here advise me please? Got an 04 k24 auto going on 3rd trans including the OEM one, this time it's having an 07 unit put in, are these units stronger?
I just did one on a 2004 Honda Accord 2.4L. This video was a big help on what I was about to get into. There is only two ways to do it, drop the frame or pull the whole engine with the tranny together from top. I dropped the frame.
The rack and pinion can stay on the frame just disconnect the high pressure hose from the pump and the rubber hose portion of the low pressure return. Remove front and rear motor mounts, A- arms, drive shafts exhaust down pipe, starter and transmission lines. Then you are clear.
If I was to ever do it again, I would take the engine and tranny out the top.
mixing hardware is crazy work
Pulled out mine from the top. Just needed my neighbor for a lil help. Also mine was Manuel. Great car🤘🏼
I went to Harvard and I’m not sure of what I know. These people sure do know their stuff.
Not a easy job 😬
Can anyone here advise me please? Got an 04 k24 auto going on 3rd trans including the OEM one, this time it's having an 07 unit put in, are these units stronger?
I pulled it from the top
It wasn’t bad
Bro any tips I’m about to do this on my automatic 😭
U do motor work where are u located
How much does this cost