Setting up our Felder K 700 s crosscut fence for angles

Today we’re going through how to move the cross cut fence how to set it up for an angle cut and what the difference accessories on the sliding cross cut sled do.
Check this out for tips on how to set your crosscut fence square and how to set it for repeatable measurements.

[@stanley8101]

This is what I need. Thanks for your video 🤠

[@paulebender]

It would be a better presentation if you understood how the machine worked before making a video. Assuming the fence is factory square is a big mistake. Take a scrap sheet and make a five sided cut to verify the accuracy. My K 940 s required squaring on both fence positions. The entire machine needed adjustments to make accurate cuts. Good luck with your new machine. Paul

[@contemporarywoods243]

Thanks @paulebender for the good feedback, we did square up the fence using the 3 cut method, it was slightly out of square. Overall we are thrilled with the ability and accuracy of this saw compared to our old cabinet saw and panel saw

[@jimpackard8059]

That looks really cumbersome in comparison to an Altendorf.

[@paulmccloskey8510]

im more confused than ever !!!!!!!!