MATLAB Simulation of a PFC Boost Converter

[@samelias2319]

could you please explain the control scheme? - the rational behind all the steps. thank you

[@notintherightmood7725]

Thank you so much for the video sir. It'd be great to see an explanation of the control scheme where you force the input current of the step-up to be a double half wave.

[@TechSimulator]

Noted

[@Syed_vlogs_YT]

Ooo wow. Really Awesome.
Can you please share me the Documentation for Controller design.
I want to know the control design in detail.

[@yi5338]

how is the PI controller coefficient calculated?

[@gbo4942]

Thank you for this video. Which control method did you use in this video? Is this avarage current control method?

[@eric4949]

Why the [Vin] multiply "1/VAC_peak" in the simulation, not multiply "1/VAC_peak^2"?
Please tell me.
I'm very curious.

[@sofiabarriuso8845]

Thank you so much for the video. When I do my simultation following your steps it takes about 4 minutes to be completed. Do you know how to speed it up? Or why can it take so long? I just put 0.6 seconds

[@dishikapoddar8121]

Sir, can you tell me how you found values for all the components in the converter?

[@barathnarayanan4333]

after very long time bro and hope you remember there is a channel
bro one request please do video on space vector technique closed loop for motor load

[@alial-khayyat8934]

Good effort

[@TechSimulator]

Thank you

[@kishorjoshi8981]

can ypu please mention the reference where this strategy came from

[@mariamkamal2408]

Is it possible to know the reference?

[@yahyaymn2781]

Thank you so much

[@kandurilakshmanpavan1580]

Can you do simulation for PFC CUK Converter

[@rachna5156]

Sir can u please tell how u tune parameter of kp and ki?

[@jason_0872]

How about PFC buck Convertor ?

[@satyajit7417]

Can u please make simulation on bidirectional PFC
Application :- ev chargers( V2V , V2G)

[@manoharchoudhary7648]

+1

[@CookiePepper]

Voltage overshoot at startup is usually not acceptable. How it could be solved?

[@TechSimulator]

soft start mechanism

[@anoopkumarniravuparambil1114]

Multiplying Unit vector with voltage control loop pi output gives an Iref of 100Hz speed. Simulation its fine, but this will not work in hardware if feedforward duty is not there. Feed forward duty + Compensator duty should be the actual duty.

[@anilkumartiwari5165]

How to decide rated power in any simulation??

[@TechSimulator]

You can select whatevr number you want

[@pulonathan6435]

Could you please upload some videos on interleaved boost converter, battery storage system with fuzzy logic controller...
Please ....🙏🙏🙏🙏🙏🙏🙏

[@TechSimulator]

noted

[@finance_time]

Sir could u plzz upload this simulation file ..so that we can run this file in our system

[@TechSimulator]

pls contact me at my email

[@montech2417]

Please make mppt with flyback

[@truongle8983]

Please give me the theory file.

[@gknaveenkumar4391]

Why there is a dead zone in the input current at every zero crossing ... Boost PFCs shouldn't get dead zone

[@montech2417]

Make flyback applications

[@psrikanth6477]

Same control diagram not working in MATLAB

[@elonmust6473]

in the PID controllers, select descrete time instead of continuous time

[@elonmust6473]

for both PID

[@jiuyi8364]

Thank you so much