moto iron springers part 2

Fitting moto iron springers to Harley dyna superglide part two.Purchased these from TC Bros,Choppers in the states and had them shipped to the UK . Also ordered a brake caliper,3/4" axle spacer,riser adapter studs and a pair of fender mounts.No problems with shipping and TC Bros where very helpful.

[@Torpi95]

now i know that im late with it being 4 years later, But do you realize that you got the wrong springer? If you look on the TC Bros site, you can see that you have a "big twin" springer that specifically says its not compatible with dynas, the tree setup shouldve been a tell. instead you should have bought SKU# 113-0114, which is under the dyna parts tab, and has an entirely different tree setup to accommodate the placement of the tanks, neck, and stem. without grinding. for anyone in the future, measure twice, cut once. research before you buy. this couldve been plug n play barring the spacers.

[@buryme2012]

they added wont fit dynas after I let them know they didn.t work.

[@Vic-ng8if]

Just fitted mine mate and was wondering how high you set the fender mounts? I've set mine at 1 1/4

[@buryme2012]

Sounds about right to me did you have any problems spacing the wheel

[@Vic-ng8if]

@@buryme2012 oh yes mate. I've used the 21 inch sporty wheel (it's an 01) and went thru a few standard spacers but in he end had to have a mate of mine make some up. All worked out well though. You are right about the forks not fitting as well mate. I had to make new stops for the frame and lift the tank back by 2 inches. Your bike looks good chum. Well done.