@@stevecopley7933 I forgot to record that. My apologies. I don’t recall nor have the car anymore for reference. I’ll pin this so someone else watching may be able to assist you. I think it’s two small fasteners holding it down - nothing exotic.
Nice video, However I would first snug all bolts down on the oil pan by hand before torquing them down. This would ensure equal pressure on the rubber seal over the surface of the oil pan.
Thank you for this helpful video! I'm going to flush my 722.6 tranny in my Benz soon. The only thing I'm not sure if I need to deal with transmission connector. I know they may leak eventually...
I didn’t myself but it’s worth looking while you’re in there. If no evidence of trouble, perhaps leave it good and alone. Thanks for watching and good luck with your project!
How did you get the other cross bracket off? I didn't see that part. Thanks.
@@stevecopley7933 I forgot to record that. My apologies. I don’t recall nor have the car anymore for reference. I’ll pin this so someone else watching may be able to assist you. I think it’s two small fasteners holding it down - nothing exotic.
Nice video, However I would first snug all bolts down on the oil pan by hand before torquing them down. This would ensure equal pressure on the rubber seal over the surface of the oil pan.
Thank you for this helpful video! I'm going to flush my 722.6 tranny in my Benz soon. The only thing I'm not sure if I need to deal with transmission connector. I know they may leak eventually...
I didn’t myself but it’s worth looking while you’re in there. If no evidence of trouble, perhaps leave it good and alone. Thanks for watching and good luck with your project!
@@DWraysGarage Thank you! 👍
Another great video!
No video on the spyder ? I would like to know more about it ,could be a cool video
There'll be a video before too long. Just got it last week so getting it fully cleaned up and ready for 🤳
I asked how much would it be to do a oil and filter change at my local shop and they said $620! Ridiculous!
What was the torque on those pan bolts?
10nM
@@DWraysGarage is that 7.4 ft/lbs torque? And thank you!
@@sluggosloan it is
👀👋