Goosse. I am watching your video because I am bored. Just got home from work. I have to say. You are funny as hell. Some of the mistakes you make might or might not be on purpouse but damm kiddo. Dammmmmm Gina. Dont rush your work. I have the same set up on my 66 and the only thing I had to add later was the roll over valve. I just have to say again. Dammmm Gina.
Now that I have finished your video, I will say that you are fired. That grinding was not acceptable. What I did was, I got some brass fitting nipples about 3 inches long with a female end for the 6AN. That way if I have to loose those babies, I can do it from the bottom of the car. I wish I can send you a pic. You are still fired. LOL
Just went to install the the fuel pump on my gbody tanksinc and ran into the same fitting issue lol glad i'm not the only one
Goosse. I am watching your video because I am bored. Just got home from work. I have to say. You are funny as hell. Some of the mistakes you make might or might not be on purpouse but damm kiddo. Dammmmmm Gina. Dont rush your work. I have the same set up on my 66 and the only thing I had to add later was the roll over valve. I just have to say again. Dammmm Gina.
I used the same thread sealant and it leaked. Third time I dropped the tank i used Teflon tape, no leaks 4 years later.
I have ran in to that but but it also could be a bad fitting have had to change the fitting out a few times
@@goosseperformance1444 Very nice build btw
Now that I have finished your video, I will say that you are fired. That grinding was not acceptable. What I did was, I got some brass fitting nipples about 3 inches long with a female end for the 6AN. That way if I have to loose those babies, I can do it from the bottom of the car. I wish I can send you a pic. You are still fired. LOL
where did you buy the access door? Great video!
Link in description below
Do you get fuel slosh issues with this tank. I got same one but at half tank or less it will slosh on launches hills and turns
No issues with that