Absolutely… also what I learned, is if the flux dries out, just add some water to it. I’ve thrown away so many little bottles of that stuff cuz it was dried up. Little bit of water brings it back to life haha
I’m not sure, you could try. I think I tried regular flux and it wouldn’t stick but I could be wrong. I’m not that good at soldering haha. I know the silver stuff works though so that’s what I buy
This hack is a game changer! I finally got the same stuff you have and going to try today!
Absolutely… also what I learned, is if the flux dries out, just add some water to it. I’ve thrown away so many little bottles of that stuff cuz it was dried up. Little bit of water brings it back to life haha
@@terjavec Worked very well! Thank for the great advice! So thankful to not be wasting a cable because 6 inches gets kinked!
@@mattvanderson absolutely, it’s a very simple repair. The first time is scary though haha
@@terjavec I had some different brazing rod from Menards and I had a hard time getting it to bond.
@@mattvanderson i never had luck with anything other than what I posted in this video
Thanks for posting ! I have all three and the rods are jacked on all three. Going to fix them tomorrow thx to your video.
That was awesome 👍
Does the flux and soldering for copper work for the cable?
I’m not sure, you could try. I think I tried regular flux and it wouldn’t stick but I could be wrong. I’m not that good at soldering haha. I know the silver stuff works though so that’s what I buy
Is there a special type of soder of flux i should use? My machine cable bent so i wanna do a repair.
Yes. Use silver solder and flux