Размер видео: 1280 X 720853 X 480640 X 360
Показать панель управления
Автовоспроизведение
Автоповтор
You’re an RF wizard Bill. I’m always amazed with what you build.
So Bill, was the error only on your Schematic, or did you actually have a 2.7 ohm resistor wired in? 73 - Rick - N3FJZ
Rick: It was a schematic error, as Walter suspected. Upon inspection (after taking it off the shelf!) I found a 2.2 k ohm resistor (red-red-red) from source to ground. 73 Bill
Nice Bill! How was the performance before the resistor swap? 73 de PA1DSP
There was no resistor swap -- the error was just a mistake in my drawing of the schematic. I always had a 2.2 k ohm resistor at the source. 73 Bill
@@soldersmoke could it be that the 560 ohm base-gnd resistors of the two AF AMP transistors are actually 5k6? The biasing doesn’t work with 560 ohm. 🧐
You’re an RF wizard Bill. I’m always amazed with what you build.
So Bill, was the error only on your Schematic, or did you actually have a 2.7 ohm resistor wired in? 73 - Rick - N3FJZ
Rick: It was a schematic error, as Walter suspected. Upon inspection (after taking it off the shelf!) I found a 2.2 k ohm resistor (red-red-red) from source to ground. 73 Bill
Nice Bill! How was the performance before the resistor swap? 73 de PA1DSP
There was no resistor swap -- the error was just a mistake in my drawing of the schematic. I always had a 2.2 k ohm resistor at the source. 73 Bill
@@soldersmoke could it be that the 560 ohm base-gnd resistors of the two AF AMP transistors are actually 5k6? The biasing doesn’t work with 560 ohm. 🧐