Yes, indeed. The original had a plastic rod, which was broken. This rod and the whole system is Metal. I just replaced it. It took me quite some time to remove the old nut in the tank hole. It was very tight. The plastic corners were stripped. I finally used a hair dryer to heat it a little. then used a pair of locking pliers to loosen it. Once that was out out of the way, the rest was easy. Thanks again. Also the tip about the handle turn degree was helpful too.
Thank you for making this so easy!
I just happened to buy the same exact handle and found your instruction very helpful! Thank you.
Same here. Thanks, Ray!
Thank you for the video. It was very helpful to fix my own stupidity.
No problem 😉 thanks for your feedback and please remember to subscribe and like the video.
Thank you, Ray. Very helpful. I have the identical lever. Will install it later today.
Thanks for your comments. Much better lever than the original.
Yes, indeed. The original had a plastic rod, which was broken. This rod and the whole system is Metal.
I just replaced it. It took me quite some time to remove the old nut in the tank hole. It was very tight. The plastic corners were stripped. I finally used a hair dryer to heat it a little. then used a pair of locking pliers to loosen it. Once that was out out of the way, the rest was easy. Thanks again. Also the tip about the handle turn degree was helpful too.
Very helpful, thanks! 🙂
Thanks for the feedback and please remember to subscribe and like the video.
Thanks, I can’t stop the long arm from moving left and right inside the tank. Any advice?
Add washers maybe 🤔
@@DIYRAY I think it’s fixed now, just wondering does yours move around or is it locked in place.
@kauaireed9006 it doesn’t suppose to move.
Great vid, thanks, go Mets!
Thanks for your comments and please remember to subscribe and like the video.
Ray did my video pop up
But, if you wanted to shorten that long brass lever, what would you use to cut it? A hacksaw?
Just shorten the chain length position.
I have that issue as well because of the ball, so what do you cut it with?
I will subscribe if you help me tweak. I followed your directions and I'm still having problems with the flush I'll do video.
Thanks for the comments. Let’s see what happens.
@@DIYRAY Are you ready
@@DIYRAY I will try to record video on here of the problem