Because of a important machine failing it will take 12 to 15 weeks. We are currently working on creating another smaller series with a different machine that is slower. So at the moment tha Last Crackers we have are only availible in the bigger Sets like 1140-B/1140-C or 1104-G etc.
Das werkzeug benötigt einen überstand von 0.5mm darunter wird nicht empfohlen das werkzeug zu nutzen. Auch wenn es teils funktioniert. Aber bei bündigen zylindern empfehlen wir immer das Ziehen mittels ZIEH-FIX Glocke.
![[1017] Puck Lock vs. Wendt Core Puller](http://i.ytimg.com/vi/va7PBIQ4CJ8/mqdefault.jpg)
![[1017] Puck Lock vs. Wendt Core Puller](/img/tr.png)
Nice tool. If we had more profile cylinders in Denmark, it would be a great tool to carry.
@@Zieh-Fix yes we have almost only scandinavian oval, but the bell puller is good at removing them
@@Zieh-Fix yes, because the 2 screws holding the oval in, can be snapped, and often give before the core comes out of the oval housing when pulling
Si je comprend bien , il permet de casser le cylindre même si il est non dépassant avec une garniture de securite ? Ça m intéresse !!!
Most crackers need 3+mm to be used. With this cracker is designed to work on 0.5mm with the help of a pulling screw.
Hi there when will you have v2 cracker back in stock ? Thanks
Because of a important machine failing it will take 12 to 15 weeks. We are currently working on creating another smaller series with a different machine that is slower.
So at the moment tha Last Crackers we have are only availible in the bigger Sets like 1140-B/1140-C or 1104-G etc.
@@Zieh-Fix ok smaller version sounds good when are these likely to be available? Thanks
@@Pauljay65 Sorry not smaller version. just a smaller run in production to hopefully have stock again sooner than thought
Und was ist wenn das nicht so nach vorne steht das Schloss?
Das werkzeug benötigt einen überstand von 0.5mm darunter wird nicht empfohlen das werkzeug zu nutzen. Auch wenn es teils funktioniert.
Aber bei bündigen zylindern empfehlen wir immer das Ziehen mittels ZIEH-FIX Glocke.
Where can I buy LOCKMASTER® Power Pull Cracker V2 ?
including pulling screws: www.zieh-fix.com/en/lockmasterr-power-pull-cracker-fuer-profilzylinder-inkl-zugschrauben-version2.html
excluding pulling screws: www.zieh-fix.com/en/power-cracker-master-professional-fur-profilzylinder-made-in-germany.html
Why would you need that tool, and why does it need to be screwed in? That cylinder can be broken off just as it is, with some pliers , or a knackrohr.
You can use this tool with or without screw. The screw allows you to also break a cylinder that only is outside 0.3mm.