Размер видео: 1280 X 720853 X 480640 X 360
Показать панель управления
Автовоспроизведение
Автоповтор
i think i had to use the hot gun from downside of the board!
yes is always safer that way
after reballing it went blurr little bit
How much heat and air you kept on that sensor coz this thing gets damages because of too littlest heat
sensor its very risky to change it but 350c. 60% air speed. Be quick. Leaded solder make faster bond. Also heat from bottom is safer.
what's that liquid its in, you will have to taker it off the sensor after, how ?
which liquid. Its no-clean-liquid flux and then clean with alcohol. Alcohol will dry itself.
What was this camera?
cctv
What kind of chip is that?
It's the sensor of the camera
@@TanajiChang hmm... thank you
@@j.lietka9406 Most welcome.
i think i had to use the hot gun from downside of the board!
yes is always safer that way
after reballing it went blurr little bit
How much heat and air you kept on that sensor coz this thing gets damages because of too littlest heat
sensor its very risky to change it but 350c. 60% air speed. Be quick. Leaded solder make faster bond. Also heat from bottom is safer.
what's that liquid its in, you will have to taker it off the sensor after, how ?
which liquid. Its no-clean-liquid flux and then clean with alcohol. Alcohol will dry itself.
What was this camera?
cctv
What kind of chip is that?
It's the sensor of the camera
@@TanajiChang hmm... thank you
@@j.lietka9406 Most welcome.