Could you PLEASE replace Shaft with a Bearing ? I would like to understand how the Bearing Internal Clearance is affected by pressing the bearing on OD hub
Hi there, I tried to simulate a similar model but with the model in half. I expected the result of reaction force in z direction (x 2) to give the same answer as if I had a complete model. Unfortunately that is not the case. Any clue where the mistake could be? I cut the model with xz plane, so I created on the corresponding faces boundary contraints with fix translation in y-direction. Another question... Can I apply the reaction force (Load force in z-direction) in an another solution to double check if it give me the desired diplacement? I tried but didnt get any result. I would appreciate it if you could give advice or show a short demo on it. Thanks.
Could you PLEASE replace Shaft with a Bearing ? I would like to understand how the Bearing Internal Clearance is affected by pressing the bearing on OD hub
Hi there, I tried to simulate a similar model but with the model in half. I expected the result of reaction force in z direction (x 2) to give the same answer as if I had a complete model. Unfortunately that is not the case. Any clue where the mistake could be? I cut the model with xz plane, so I created on the corresponding faces boundary contraints with fix translation in y-direction.
Another question... Can I apply the reaction force (Load force in z-direction) in an another solution to double check if it give me the desired diplacement? I tried but didnt get any result. I would appreciate it if you could give advice or show a short demo on it. Thanks.
Very good. Nicely explained.. Keep it up...
Like it ! Thank you for sharing this...