Behringer UB-Xa and UB-Xa D update 2.0 - a brief overview

Hi, in this video I want to share some informations about the firmware update 2.0 and also about some workflow improvements.
You can check my other tutorial as well which was using the original release firmware.
• Behringer UB-Xa Walktr...
I didn't cover every detail, however here are some additional informations about the update (possibly not complete):
New modulation sources in the matrix:
Drift1 (VCO1 drift, a randomised per voice drift factor applied to VCO1)
Drift2 (VCO2 drift, a randomised per voice drift factor applied to VCO2)
DriftF (VCF drift amount, a randomised per voice drift factor applied to VCF)
New destinations:
FiltDriftA (VCF tuning drift amount)
FiltDriftS (VCF tuning drift speed)
OscDriftA (VCO tuning drift amount)
OscDriftS (VCO tuning drift speed)
In LFO sync mode, dotted notes are now resetting correctly.
Fixed:
"thumping issue"
A reset all controllers message was resetting the mod wheel to 0, meaning maximum performance LFO modulation instead of no modulation.
After resetting factory patches the routine will read back and verify that the patches have indeed been written to flash.
After resetting factory patches, the patch names cache is invalidated in the select encoder menu. Correct patch names should now be shown immediately.
Fixed channel pressure messages not sending if selected as the 'Aftertouch Out' and forwarding ArpSeqSel is deselected in MIDI Forwarding menu.
Fixed impossible to start Arpeggiator or Sequencer when local control is off and sync mode is set to internal.
Fixed behaviour of CC in dual mode
Synthtribe now contains a basic librarian to store and organize patch banks.