The $850 Polaris Ranger Is A Runner!

If you haven’t seen the first part of this project, you can find it in my videos.
In this video, I finish up the top end installation on the $850 Polaris Ranger 500 I bought, and immediately put it to work!

[@lloydfloyd751]

Runs good

[@MegaTank2000]

Your video inspired me to add temp gauge to my Ranger. How did you ground the sensor? I see two wires coming off it but didnt see it in detail. Thanks for making these videos!

[@CumminsDriver]

Hey thanks for the comment! I actually just soldered a wire right to the brass sensor body(its not pretty), being sure not to get it too hot, and then grounded it to the most convenient spot from there. I cant remember if it was the frame or engine. But possibly an easier way would be to just use a thin hose clamp around the sensor and slide some bare wire between the clamp and sensor, and tighten it up, then ground the other end. Good eye catching the grounding issue!