Connecting Closed Loop Motors to OpenBuilds BlackBox using a Break out Board

We have designed a Break-out-Board for Openbuilds BlackBox that allow access to the motor signals. The BoB sandwich in between the two PCBs making up the BlackBox. A series of screw terminal connectors now allow you to connect external drivers like Closed Loop to the BlackBox.
This is a short introduction to the BoB that can be sourced from makersupplies.dk here: makersupplies....
Please note:
When using this BoB the height will increase so the original sides will no longer fit. Also you should expect to void the warranty of the BlackBox.
Thanks to our friend Henrik for making the design!

[@DavidtheSwarfer]

you should say 'direction' instead of 'dir' since 'dir' is a shortened form of direction used only for labelling, not when speaking. English is tricky (-: