Silicone is a very bad idea, as it does not dry and/or evaporate. Therefore it stays very slick, leaving your fitting loose & prone to leaking. If anything, use a SMALL amount of WD-40, which will dry up from the heat of the engine, leaving an air-tight seal & a snug fitting. Ultimately, you want the hose to go on hard & dry.
Thank you very much sir very easy step by step
love the parkway drive in the intro haha
Changed to a new intro but kept the song haha
That intro sounds familiar. I can't remember what song it is tho.
Parkway Drive - Karma
Good video, next time use silicon spray to slip on the hoses much easier. 👍🏽
Silicone is a very bad idea, as it does not dry and/or evaporate. Therefore it stays very slick, leaving your fitting loose & prone to leaking. If anything, use a SMALL amount of WD-40, which will dry up from the heat of the engine, leaving an air-tight seal & a snug fitting. Ultimately, you want the hose to go on hard & dry.
So no need for the restrictor pill?
They never mentioned anything during tuning, so I’m guessing it was fine with just the boost controller
What diameter hose did you use?
Honestly I’m not sure what diameter the hose was, it came with the boost controller.
When i hooked it up this way it was just at wastegate pressure
Sorry for the late reply, 300+ comments were "being held for review" for some reason. I believe you will need a tune to have better control over it.