MS08a. [Stepper Motor] Stepper Driver Wring with PLC 24v Pulse Signal (Resister for TB6600 FMD2740C)

#steppermotor #TB6600 #FMD2740C
1/2: Control Stepper Motor with a Siemens S7-1200 PLC • MS08b. [Stepper Motor]...
2/2: Motion Control Programming for Stepper Motor • MS08c. [Stepper Motor]...
Key Words: Stepper Motor drivers: TB6600; FMD2740C; Siemens S7-1200 PLC; Stepper Motor
Next video: Control a stepper motor with a Siemens S7-1200 PLC • MS08b. [Stepper Motor]...
This video introduces the resister selection when the PLC pulse output voltage is 24v for connecting the 5v inputs from stepper motor drivers such as TB6600, FMD2740C, or DM542.
I appreciate you could buy me a coffee via the PayPal link below:
www.paypal.com...
Siemens Control Playlist: • Siemens Controls
Motion Control Playlist: • Motion Control
[DC Motor]
MS04a. Setup Positioning Axis via Analog Output, DC Motor, and Encoder
• MS04a. [DC Motor Posit...
MS04b. Program DC Motor Positioning Control via S7-1200 and TIA Portal
• MS04b. [DC Motor Posit...
[Stepper Motor]
MS08a. Stepper Driver Wring with PLC 24v Pulse Signal (TB6600 FMD2740C)
• MS08a. [Stepper Motor]...
MS08b. 1/2 Control Stepper Motor with a Siemens S7-1200 PLC - Technology Object
• MS08b. [Stepper Motor]...
MS08c. 2/2 Control Stepper Motor with a Siemens S7-1200 PLC - Motion Control Programming
• MS08c. [Stepper Motor]...

[@hetanhawke2354]

Thanks Mr. You are the best

[@electricalautomation]

Glad you enjoy it, nice to see you again!

[@eizzuddinnawawi5349]

Hi Sir,
May i know your servo motor specs?

[@NgTanLoi7979]

Thanks! You is the best ❤❤❤

[@electricalautomation]

Thanks! Welcome!

[@huyphanducnhat1609]

can i use DI/DO module attached to s7 317-2 PN/DP and set output through the DI port of DI/DO module instead via PLC?

[@electricalautomation]

Basically no, not regular do module, you have to use the CPU 'PTO' output. The regular do can not do high frequency, and it will cause your step motor has to run very slow or miss the speed command.

[@ringoautomation435]

Good job !

[@electricalautomation]

Thanks!