Did you your bumper need a little bit of heat to get onto the front end? I have a RS5 one and it clips in on one side but the other side is a little low and needs a lot of pressure?
I ordered mine, question? They say I need the bumper supports ? That they offer for 450$. Is that true? Or do I just pull my Audi a6 front bumper off and direct replace it with the rs6 bumper I have a 2016 a6 c7.5
@@praneetsingh7351 the headlight housings are fully adjustable it you look behind the mounting tabs of the headlight there will be a piece that looks like a washer and bolt combined. Those are adjustable you can thread them in and out to adjust where the headlight sits. They are reversed thread so lefty tighty righty loosey😂. Best of luck!
So this video is just on how to assemble the new bumper not how to actually put it on the car. There are sensors and the covers dont fit with the sensors at the same time...
Did you your bumper need a little bit of heat to get onto the front end? I have a RS5 one and it clips in on one side but the other side is a little low and needs a lot of pressure?
I ordered mine, question? They say I need the bumper supports ? That they offer for 450$.
Is that true? Or do I just pull my Audi a6 front bumper off and direct replace it with the rs6 bumper
I have a 2016 a6 c7.5
You should just be able to remove the old bumper and install the new one unless you have missing or broken parts on your car
Can you do a video of where all the screws go?
Im totally lost!
I will try I have to take the bumper off soon if I remember I will
Can I do this swap but keep my original headlights? I have a 2013
did the bumper come that color
I got the same bumper, grills and all. How hard was it to mount the bumper? I'm running into some fitment issue trying to even get it lined up
I was lucky enough to not have any major issues. There’s a lot of adjustments with these cars what’s not lining up for you?
@@dmcbuilds1891 it’s just under the headlights I’m not able to push the bumper in more. Rest of that sides look and fit fine
@@praneetsingh7351 the headlight housings are fully adjustable it you look behind the mounting tabs of the headlight there will be a piece that looks like a washer and bolt combined. Those are adjustable you can thread them in and out to adjust where the headlight sits. They are reversed thread so lefty tighty righty loosey😂. Best of luck!
@@dmcbuilds1891 I'll try that out! Thank you!
@@praneetsingh7351 no problem good luck
So this video is just on how to assemble the new bumper not how to actually put it on the car. There are sensors and the covers dont fit with the sensors at the same time...
Hey I have a question my fog lights Grill doesn't lineup with the fall light
Mine didn’t either and my girlfriend has an a3 that we put a RS3 bumper on and it had the same issue
That's not fog light that's for adaptive cruise control
No there definitely fake fog lights adaptive cruise is one single piece in the middle of the bunper
Where did you get the bumper
I’m not 100% sure of the website but it was a bkm bumper