@@birdbangbobarui if it’s new then most guns come under the power states, which is why I get the shop to check them first, the last one was a kricket that was 9.8 straight out the box and a cart that said 11.3, bit shit for a £1k gun from one of the UK’s big gun shops. So, new, screw the adjuster in that you can see on the rear, used, new spring.
hello friend ... I have a P15 and it is leaking air or in this entrance of the probe fil or else by the manometer .. the procedures to do is this and change the orings!? If I can help, I'll be grateful.
There’s one you can see under the manometer. If you disassemble and leave the black spring loaded sleeve off then screw on the manometer you can use soapy water to test the seal.
custom bolts thank you for the help, my friend ... tomorrow I'll try to heal the leak. I do not know how to shave well in the carbine even more I will try, your video will be very useful. thanks
well, i accidentally unscrewed the cylinder. which then dumped all the air and i dumped my bowels, so, theres a warning these things are dangerous. there should be a grub screw on the underside which can be gently backed off to release. it was also used in manufacture to achieve the hole through to the barrel and so then capped off. if your unsure just shoot it and shoot it
Thanks for the video, how can you make the p15 more power mate
Send it to a gunsmith for tuning once you have your FAC? Or if it’s a slight increase either a new hammer spring or screw the adjuster in the back.
@@ellelephant mines is falling shy about 300 fps from what the manual says
@@birdbangbobarui if it’s new then most guns come under the power states, which is why I get the shop to check them first, the last one was a kricket that was 9.8 straight out the box and a cart that said 11.3, bit shit for a £1k gun from one of the UK’s big gun shops. So, new, screw the adjuster in that you can see on the rear, used, new spring.
Sorry, missed a major point… 300fps loss, if it’s relatively new, take it back under warranty.
gonna cost a fortune. they are over seas
sorry MrT but was that spring a bit hot after being on the bench grinder for a bit lol
hello friend ... I have a P15 and it is leaking air or in this entrance of the probe fil or else by the manometer .. the procedures to do is this and change the orings!? If I can help, I'll be grateful.
Davi Makalyster there’s a later video that explains leak points. And yes, they are just o rings.
There’s one you can see under the manometer. If you disassemble and leave the black spring loaded sleeve off then screw on the manometer you can use soapy water to test the seal.
custom bolts thank you for the help, my friend ... tomorrow I'll try to heal the leak. I do not know how to shave well in the carbine even more I will try, your video will be very useful. thanks
custom bolts here in Brazil almost has no videos on P15 yet!
Davi Makalyster make some 😉
How do you degass?
sprouts
well, i accidentally unscrewed the cylinder. which then dumped all the air and i dumped my bowels, so, theres a warning these things are dangerous. there should be a grub screw on the underside which can be gently backed off to release. it was also used in manufacture to achieve the hole through to the barrel and so then capped off. if your unsure just shoot it and shoot it
🤗👏👏😍😍😍