Options b. Inject 0.7 v @ 1 amp on any inductor. If voltage drops and amp raise. The you found the shorted rail. If all are OK. The inject 0.9v at @1.5.amp on current sense resitor If voltage drops and amps raise then u know the short is on 19v rail to. Then go t Bq chip. Check 6v @ regn pin 2.4v @acdet 2.4-2.7 @acok. The check. 1st and second mosfet gate voltage should be 6v greater than charging voltage . If no 6v at regen pin then 1st and 2nd fet won't allow 19v to pass to current sensor
Steps to check with out long story's. 1. Multimeter on ^ beep mode^. 2. Black prob on ground. Then Option [A] Place red probe on all solder joints marked ^JPF^. if it beeps and ohms close to 0. Then de Solder there. TEST each side of the ^JPF^ joint see wich side beeps or had low ohms. Follow the pad and see what the rail powers. Jpf split Pad away of coil is towards the Rail.. Towards coil is the vrm. Inject 0.7 v .. -> use thermal camera, Rosin flux atomizer, ,spray ipa., check close what gets hot. Replace. Part if possible. Or remove the cap. NEVER USE DC BENCH ON 19V RAIL.. DO NOT INJECT IF YOU HAVE NOT DISCONNECTED THE ^JPF^ POINTS AFTER THE COILS. IF High side fet short on any power rail section u will destroy the board. Inject 0.7v on 19v rail is safe.
I hve lot of things to learn from you... thanks again
Options b.
Inject 0.7 v @ 1 amp on any inductor.
If voltage drops and amp raise. The you found the shorted rail.
If all are OK. The inject 0.9v at @1.5.amp on current sense resitor
If voltage drops and amps raise then u know the short is on 19v rail to.
Then go t Bq chip. Check 6v @ regn pin
2.4v @acdet
2.4-2.7 @acok.
The check. 1st and second mosfet gate voltage should be 6v greater than charging voltage .
If no 6v at regen pin then 1st and 2nd fet won't allow 19v to pass to current sensor
keep going
you will earn money ASAP Hope so !
I have some question.
How could I get touch with you ?
Steps to check with out long story's.
1. Multimeter on
^ beep mode^.
2. Black prob on ground. Then
Option [A]
Place red probe on all solder joints marked ^JPF^. if it beeps and ohms close to 0. Then de Solder there. TEST each side of the ^JPF^ joint see wich side beeps or had low ohms.
Follow the pad and see what the rail powers. Jpf split Pad away of coil is towards the Rail.. Towards coil is the vrm.
Inject 0.7 v .. -> use thermal camera, Rosin flux atomizer, ,spray ipa., check close what gets hot. Replace. Part if possible.
Or remove the cap.
NEVER USE DC BENCH ON 19V RAIL..
DO NOT INJECT IF YOU HAVE NOT DISCONNECTED THE ^JPF^ POINTS AFTER THE COILS.
IF High side fet short on any power rail section u will destroy the board.
Inject 0.7v on 19v rail is safe.
Please share the e-book link
thanks alot keep it up (:
too bad the sound is just too low,can hardly hear
Sorry my bad
Do you always switch bench power supply to 19v, even if we test 3.3voltage and so on?
your explanation is too difficult