I have one video I need to find and post It. Boat was literally almost too fast. I have still vid caps that show massive rooster tail. And how much the 33 pound boat is out of the water! Fast!!
Thanks man! It is a beast of a boat. I hate trying to wrestle it up from the basement to get it to the lake. Trying not to bang it into stuff from basement to truck!
Well, I sold the boat almost 2 years ago. They don't leak, they ran fine. They were a little tight though. Needs lots of break in time to loosen up. New owner seems to be using it a lot so that is good. Thanks for question.
Sorry. I actually sold this boat to pay for my twin outboard Skater I built. I can tell you it was incredibly fast! That green Bonzi was a bit too fast even on 6s per side. I may have a video sometime I can post but I really need to dig through some files. Thanks for checking out my stuff.
@@boatwerks That's awesome! You have a Dumas Skater (32foot)! I'm going to check out your channel for sure now. I have always wanted one. I had a full size 1987 Skater 21 foot with a 225 Merc ProMax. It did 89.6 mph on GPS. Miss that boat.
I've been searching videos for a build using the Arrow Sharks before pulling the trigger on a twin setup. Are you sold on their durability and performance?
Yes. I like them a lot. Seem to hold up well. The gears are nicely meshed and require break in period..like a few runs. They do not even leak any lube from the case. I would buy more if needed.
Thanks for compliments on build. Run time is based on the battery size in mah, not cells. I had 6000mah 6 cell per motor, and was only getting about 6 minutes if good fast runs. If I had 8000 to 10,000mah I would have had longer run times. Thanks for asking. Glad you like the build. I sold that boat to pay for my Skater53 with twin outboards. I like the Skater much better!
@@vigilanterc Yes it’s a very nice build for sure. I’m working on a MHZ Hunter hull and going brushless and the run times quotes I get from people are just all over the map. So I appreciate your input!
Cool! I have the same boat with twin C/R AMPS outdrives with a 1:1 Aeromarine gear box, a funcraft marine gas motor, 20MPH actual (GPS). Home made quad "wet" exhaust with the Apache Indian head decals #69. Looks AWESOME in the water!
I do have to come clean, I did sell ONE. The large green Bonzi Epic 60. However, that was get money to build the 53" Skater with MHZ 1/5 scale outboards.
@@aspenmeyer2774 depending on power you are using 65mm should be best. I say that because arrow shark 67mm are actually reworked down to 65mm this is easier on a gear drive system. On 6s my boat was plenty fast. On more power go smaller on props a little. Gears in drives will thank you.
Sweet build buddy! I’m thinking my next big boat build and that looks like a winner!
Thanks for sharing!
Sweet boat for big boys 😉 Excellent set up !!
what a great boat! Thank you for the wonderful video!
Love to see a run video on the water
I have one video I need to find and post It. Boat was literally almost too fast. I have still vid caps that show massive rooster tail. And how much the 33 pound boat is out of the water! Fast!!
You have some awesome boats dude !
Damn another badass boat build by vigilanterc! love it man . the wrap is excellent. this one dwarfs the M41 next to it.
Thanks man! It is a beast of a boat. I hate trying to wrestle it up from the basement to get it to the lake. Trying not to bang it into stuff from basement to truck!
vigilanterc i hear you there.
Sand Scorcher my 1st true RC.....
Thats awesome. I have a Sand Scorcher as well. But mine is the rerelease kit. I love it.
How are Arrow Shark outdrives holding up ?
Well, I sold the boat almost 2 years ago. They don't leak, they ran fine. They were a little tight though. Needs lots of break in time to loosen up. New owner seems to be using it a lot so that is good. Thanks for question.
Looking Forward to a running video
Sorry. I actually sold this boat to pay for my twin outboard Skater I built.
I can tell you it was incredibly fast! That green Bonzi was a bit too fast even on 6s per side. I may have a video sometime I can post but I really need to dig through some files. Thanks for checking out my stuff.
@vigilanterc i have seem all of your boat videos. I recently built a dumas skater with twin tfls it on my channel
@@boatwerks That's awesome! You have a Dumas Skater (32foot)! I'm going to check out your channel for sure now. I have always wanted one. I had a full size 1987 Skater 21 foot with a 225 Merc ProMax. It did 89.6 mph on GPS. Miss that boat.
We need a video of this boat running 😱
Unfortunately I sold it. I may have to dig up the only video I made a couple years ago. Ran really well.
Sick build!! Way cool M8! What do you think about Oxidean Marine catermaran that does 108mph stock for 1400.00? Worth it?? Thank you 😊
I've been searching videos for a build using the Arrow Sharks before pulling the trigger on a twin setup. Are you sold on their durability and performance?
Yes. I like them a lot. Seem to hold up well. The gears are nicely meshed and require break in period..like a few runs. They do not even leak any lube from the case. I would buy more if needed.
What type of run times did you get with the 6s set up? Great build!
Thanks for compliments on build. Run time is based on the battery size in mah, not cells. I had 6000mah 6 cell per motor, and was only getting about 6 minutes if good fast runs.
If I had 8000 to 10,000mah I would have had longer run times. Thanks for asking. Glad you like the build. I sold that boat to pay for my Skater53 with twin outboards. I like the Skater much better!
@@vigilanterc Yes it’s a very nice build for sure. I’m working on a MHZ Hunter hull and going brushless and the run times quotes I get from people are just all over the map. So I appreciate your input!
@@5150BlackDog sounds great. Just glad I can be of help! Any time if you need anything just ask. I've been doing this stuff forever!
Hi Steven, can we see this boat running ? I have an Aeromarine Apache 56'' with 2 M8 Z-Drives but no motors yet !
Cool! I have the same boat with twin C/R AMPS outdrives with a 1:1 Aeromarine gear box, a funcraft marine gas motor, 20MPH actual (GPS). Home made quad "wet" exhaust with the Apache Indian head decals #69. Looks AWESOME in the water!
That is so sweet do you ever sell them?
Sorry, I only build for me. And usually don't sell. I keep all my best ones. But thank you for asking.
I do have to come clean, I did sell ONE. The large green Bonzi Epic 60. However, that was get money to build the 53" Skater with MHZ 1/5 scale outboards.
A idea to reduce camera shake/ mini tripod w/gooseneck
I am making a big v hull boat with a home made drives
Have u tried it on 8s
No. I sold it a few weeks ago. Only 6s
I'm building a 72" CRC cat putting a similar running gear in as u was wondering how it worked with the 67mm props was it under or over propped
@@aspenmeyer2774 depending on power you are using 65mm should be best. I say that because arrow shark 67mm are actually reworked down to 65mm this is easier on a gear drive system. On 6s my boat was plenty fast. On more power go smaller on props a little. Gears in drives will thank you.