Make sure you have a STUPID long deep well. 2" DEEP WELL ISN'T LONG ENOUGH TO REACH THE BOLT ON THE TOP. You can get the socket on with the stupid long shank, but it'll prevent you from sticking the ratchet on. Thanks a lot toyota!
@@JoeGoldberg577_ I never got mine out. I ONLY have a 2" and my drivers side would need at least 2.5" to get the socket on the nut AND the ratchet on the socket. Mine is a 2005. I ended up fishing out an led bulb that fell off INSIDE the housing after a couple hours of cutting my fingers up. It's pretty ridiculous!
Thanks, I just did mine. It is not really necessary to remove the bottom trim 1:26 to 1:50.
Great job! 👏👏 You made it look so easy.
4:06 there are two hoses. What’s the small one for ? Because I think I have a leakage.
Pretty sure that's a windshield washer fluid line.
Look great thanks for the vid king. Im looking to open my housing. Any idea house strong the adhesive is? Think a heat gun and pry tool will work?
Thank you. I have no clue as to what is involved in opening the housing. As you can see in this video, I didn't attempt to do that.
Make sure you have a STUPID long deep well. 2" DEEP WELL ISN'T LONG ENOUGH TO REACH THE BOLT ON THE TOP. You can get the socket on with the stupid long shank, but it'll prevent you from sticking the ratchet on. Thanks a lot toyota!
How long and where should I get it ? I experienced this today
@@JoeGoldberg577_ I never got mine out. I ONLY have a 2" and my drivers side would need at least 2.5" to get the socket on the nut AND the ratchet on the socket. Mine is a 2005. I ended up fishing out an led bulb that fell off INSIDE the housing after a couple hours of cutting my fingers up. It's pretty ridiculous!
THANKX
🤙🏽
How long was the deep socket you used?
Just a typical 2" socket
Camera is jumping all over the place