CUSTOMER STATES PORSCHE DEALER WANTED $3K FOR FRONT BRAKES! HOW REPLACE PORSCHE MACAN FRONT BRAKES!

Today I show you how to replace front brakes on a Porsche Macan enjoy!
Tools used in this video.
Milwaukee 1/2in impact gun- amzn.to/3VOGSVU
Sunex 1/2in socket set- amzn.to/3B8zHAe
Gearwrench 3/8 ratchet- amzn.to/3C3HmjO
Triple square set- amzn.to/3KaOhLi
Hammer set- amzn.to/3gWBS2W
Milwaukee 3/8 impact ratchet- amzn.to/3XTU9i4
Pry bar set- amzn.to/3YoerQc
Caliper hook- amzn.to/3Ub8G7m
Pliers set- amzn.to/3nIuF9z
Milwaukee 3/8 stubby impact- amzn.to/3JvCw2G
Torx set- amzn.to/3KfvUos
Angle grinder- amzn.to/3FmNVjr
Angle grinder cleaning disks- amzn.to/3H8rY90
Caliper piston ratchet tool- amzn.to/3KBPL2g
Caliper piston squeeze tool- amzn.to/3m9OaaF
Wire brush- amzn.to/3UdPDt7
Caliper grease- amzn.to/3ZKZt74
As a amazon associate I do earn a commission on qualifying sales if you use the link.
I'm not sponsored everything shown here is purchased with my own money and are used by me in everyday work.
Disclaimer:
Due to factors beyond the control of The Enthusiast Mechanic, it cannot guarantee against unauthorized modifications of this information, or improper use of this information. The Enthusiast Mechanic assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. The Enthusiast Mechanic recommends safe practices when working with tools or equipment seen or implied in this video. Due to factors beyond the control of The Enthusiast Mechanic, no information contained in this video shall create any express or implied warranty or guarantee of any particular result. Any injury, damage or loss that may result from improper use of these tools, equipment, or the information contained.

[@HybridGt2052]

In the uk we call the multi-spline socket a torx socket or bit. Quite common on European cars and bikes. I know the suspension is based on the q5 but its crazy how similar it is to my 2004 a6, right down to the outer cv joint.

[@michaelr.ingelsby1975]

Great in depth! What was the approximate brake pad thickness at time of this job, 2mm or 3mm?

[@TheEnthusiastMechanic]

This was done a while ago, but they were pretty low. I don’t remember exactly the specs.

[@whitesixromeo]

Yes!!! Great content.

[@TheEnthusiastMechanic]

Appreciate it!

[@MrNanah38]

They are called clam shell i think.