Looks a bit like the Searco post puller. Throwing this one over your shoulder and walking up on the hill may be a bit difficult. But for it's limited scope it works quite well.
Super made .in 5 minutes no one digs out. Next time take a longer rod for pumping that protects the back. 2 side blows with the big hammer and old board in between. Then you have it even in 3 minutes loose. I drew 50 fence posts with Betong. From the construction armor the side window above a boat winch costs 15 euro new draws up loose 1 ton. 3xan the crank was also great. Great video and good luck best regards andy Super gemacht .in 5 min grabt das keiner aus. Nimm nächste mal eine längerstange zum Pumpen das schont den Rücken. 2 Seitliche Schläge mit den Grossen Hammer und altes Brett dazwischen .Dann hast du es sogar in 3 minuten locker. Ich habe 50 Zaunsäulen sammt Betong gezogen . Von der Baurüstung das Seitenfenster oben eine Bootsseilwinde kostet 15 euro neu zieht bis locker 1 Tonne . 3xan der Kurbel geleiert ging auch super. Tolles Video und weiterhin viel Glück liebe Grüße andy
I see your back support bar bent when the pressure was applied to at about 2.10min other than that looks ok small tip, on the second wrap of the chain put it below the first one and it grips quicker and tighter and won't slide like it did at 5.50.Try it and you will see what I mean
I have pulled up steel posts like that. I just wrap the chain around the post and hook it to my 6' front end loader bucket on my tractor. A few pushes and pulls against that post will loosen it up. All you have to do is pull the handle on the front end loader and everything comes out of the ground. After the 1st one is finished I go to the next 200 posts. It doesn't take long at all.
Super gemacht .in 5 min grabt das keiner aus. Nimm nächste mal eine längerstange zum Pumpen das schont den Rücken. 2 Seitliche Schläge mit den Grossen Hammer und altes Brett dazwischen .Dann hast du es sogar in 3 minuten locker. Ich habe 50 Zaunsäulen sammt Betong gezogen . Von der Baurüstung das Seitenfenster oben eine Bootsseilwinde kostet 15 euro neu zieht bis locker 1 Tonne . 3xan der Kurbel geleiert ging auch super. Tolles Video und weiterhin viel Glück liebe Grüße andy
If I had a John Deere and a 3 point, this would be a no brainer. In addition, this outfit is not especially powerful using a 3 ton long stroke ram. A Hi-Lift jack and the cheap SAFE JACK accessories has all the power and would be very portable. The lift arm is very short and so it's arc swings back quickly putting a lot of bending moment on the frame.
well done.... that was well set in there and probably just a bit bigger than would have been expected.. Off the shelf i think it would be a great buy!
Looks a bit like the Searco post puller. Throwing this one over your shoulder and walking up on the hill may be a bit difficult. But for it's limited scope it works quite well.
Super made .in 5 minutes no one digs out. Next time take a longer rod for pumping that protects the back. 2 side blows with the big hammer and old board in between. Then you have it even in 3 minutes loose. I drew 50 fence posts with Betong. From the construction armor the side window above a boat winch costs 15 euro new draws up loose 1 ton. 3xan the crank was also great. Great video and good luck best regards andy
Super gemacht .in 5 min grabt das keiner aus. Nimm nächste mal eine längerstange zum Pumpen das schont den Rücken. 2 Seitliche Schläge mit den Grossen Hammer und altes Brett dazwischen .Dann hast du es sogar in 3 minuten locker. Ich habe 50 Zaunsäulen sammt Betong gezogen . Von der Baurüstung das Seitenfenster oben eine Bootsseilwinde kostet 15 euro neu zieht bis locker 1 Tonne . 3xan der Kurbel geleiert ging auch super. Tolles Video und weiterhin viel Glück liebe Grüße andy
How would it fair up pulling a strainer post driven in 4ft with a post knocker
I see your back support bar bent when the pressure was applied to at about 2.10min other than that looks ok
small tip, on the second wrap of the chain put it below the first one and it grips quicker and tighter and won't slide like it did at 5.50.Try it and you will see what I mean
basic half hitch works best
Great product saves huge amount of time
I have pulled up steel posts like that. I just wrap the chain around the post and hook it to my 6' front end loader bucket on my tractor. A few pushes and pulls against that post will loosen it up. All you have to do is pull the handle on the front end loader and everything comes out of the ground.
After the 1st one is finished I go to the next 200 posts. It doesn't take long at all.
I suggest you use a longer poll to pump the jack up
he just needed a cheater bar
Pressure gauge added would show when pumping is required.
Super gemacht .in 5 min grabt das keiner aus. Nimm nächste mal eine längerstange zum Pumpen das schont den Rücken. 2 Seitliche Schläge mit den Grossen Hammer und altes Brett dazwischen .Dann hast du es sogar in 3 minuten locker. Ich habe 50 Zaunsäulen sammt Betong gezogen . Von der Baurüstung das Seitenfenster oben eine Bootsseilwinde kostet 15 euro neu zieht bis locker 1 Tonne . 3xan der Kurbel geleiert ging auch super. Tolles Video und weiterhin viel Glück liebe Grüße andy
You've Got air in your pump or it's low on oil..
6:23-24 that's some serious overhang.!!!
This guy must work for the city or the government.
Dont get it !!!!! Whats the tie and suit for...
he's the town mayor supervising where the communitys $400 is going.
Wow then it must hv been a must. :)
If I had a John Deere and a 3 point, this would be a no brainer. In addition, this outfit is not especially powerful using a 3 ton long stroke ram. A Hi-Lift jack and the cheap SAFE JACK accessories has all the power and would be very portable. The lift arm is very short and so it's arc swings back quickly putting a lot of bending moment on the frame.
How about, some jack oil in there, it only takes a bite about 3/4of the way down.
It reminds me of a really bad dentist I once knew.
You made that look SOOoooooo difficult.
Just use a high lift jack
Need a 10ton jack to do 1ton work. If that's a 20ton, it needs about 40tons
Very impressive.
Why not tap it with a sledge hammer when you pause .
I wonder how he got the chain to grab the post
Friction plus binding.
.
just let my wife drive through the gate...post wiil fall over.....
This farm doesn't have a tractor with a 3 point? That would take two seconds to remove.
Give my regards to Charlie!
video quality isn't very good but you can see how hard it would be to remove the post
quiker put chain round it pull it with 4 x 4 derrr
Not sure i'd want my face that close to a chain under that much pressure
Need some solid rubber tires on that thing!
hes making sure the tie gets his money worth lol
A longer handle would make it easier.
News flash..tractor recently invented.
it does not work,,,,may be next time...
to much hard work, like other watchers have said use a LONGER JACKING BAR makes life much easier
Water my friend
thats how i felt after i got a tooth yanked..
Good job he only removed one they would have run out of daylight.
5 min and the tow hook on my pickup...
3 people 10 minutes 0ne disc cutter 30 seconds...
Come on gringo!
but all you city slickers go ahead a buy that boat anchor
Let the girl do it .....
all i see is a great way to fuck up your face. that chain snaps and bam! someone looses their face and someone else looses their company!
Nice toy.
that guy is way out of shape!
+RON G
I thought he was in the process of expiring .....
Ineptitude short with bad sound and a guy who is no physicist. Just a waste of time.
O
not impressed at all
junk