Luckily it started on the course adjustments from when it was purchased & only needed fine tuning once running. You must get them hot enough to fully vaporise the fuel before trying to bust a gut spinning them over. Set half compression lever & swing the wheel in reverse direction until it hits full compression. This will cause it to fire, forcing the flywheel back the other way running half compression. Drop the compression lever to get it running at full power. Did you get yours running yet?
Hi i just started my 3.5 hp tangye hot tube but it only run for about 5min so i cleaned out the fuel hole where it goes on to valve, and it stated straight away but only run for 5 min , do you run yours on straight kero i was told to use 50/50 petrol kero any suggestions on what it might be.
Very nice!
Luckily it started on the course adjustments from when it was purchased & only needed fine tuning once running. You must get them hot enough to fully vaporise the fuel before trying to bust a gut spinning them over. Set half compression lever & swing the wheel in reverse direction until it hits full compression. This will cause it to fire, forcing the flywheel back the other way running half compression. Drop the compression lever to get it running at full power. Did you get yours running yet?
cool!
this thing sounds hilarious :-)
i think it might not of been hot enough, or was getting to much fuel some people say the hot tube has to be very very hot before they will start
where do you have your fuel needle when you start it do you have it around where it says start
Where can I purchase the 3 way Tap to the Vapouriser
Hi i just started my 3.5 hp tangye hot tube but it only run for about 5min so i cleaned out the fuel hole where it goes on to valve, and it stated straight away but only run for 5 min , do you run yours on straight kero i was told to use 50/50 petrol kero any suggestions on what it might be.
Hi i have a 7hp AA Tangye any tips on starting them