You are using the feedback for switch position correct? Not occupancy or track power? What are you using for the feedback sensor a DR4088 with a resistor?
Mike, the answer is probably a lot longer than I can reply on a YT video, but feel free to ask my more questions over on Discord. For occupancy detection, I am using the DR4088CS or YD6016ES-CS. For turnout feedback, I am using the DR4088GND or YD6016ES-GND. Some are the S88N modules and other are the LocoNet version. The GND units do not require anything (at least with the Cobalts) outside of connecting wires from the SPDT on the switch motor to the GND.
![Human[c]ity Junction](http://yt3.ggpht.com/s-GGdjwwdg82OCA3sntPpYq56iaPvmIeRwyN8-d5ydwiWSJMvt_LTof7-NVOzXTIo9ayX70p1lY=s48-c-k-c0x00ffffff-no-rj)
![NLE Choppa - Or What ft. 41 (Orchestra Mix) [Official Music Video]](http://i.ytimg.com/vi/biOFASEgSOM/mqdefault.jpg)
A very clever solution for the LEDs!
Mike, thanks!!🙏
What a smooth operation on that switch machine, very nice heath! Take care!
Thanks 👍
Success is always a great thing but you are not finished yet , great job Heath
Very true! But did you have to remind me?
😊😊 very well done 👍
Thanks for the visit
What you said. I'm not very savvy with this electrical stuff. But do find it interesting watching you figure stuff out.
One step at a time, I am figuring it out as you go.
@@HumancityJunction A much better man than I, but we knew that.
Say that again 😮😮😊
While standing on my head? Drinking a glass of water? In a foreign language?
Awesome, you're practically finished now. 🤣
Should be finished in a day or two.
Are the leds going in the fascia or in a signal tower?
Neither. The plan is to put them under the tracks
You are using the feedback for switch position correct? Not occupancy or track power? What are you using for the feedback sensor a DR4088 with a resistor?
Mike, the answer is probably a lot longer than I can reply on a YT video, but feel free to ask my more questions over on Discord.
For occupancy detection, I am using the DR4088CS or YD6016ES-CS.
For turnout feedback, I am using the DR4088GND or YD6016ES-GND.
Some are the S88N modules and other are the LocoNet version.
The GND units do not require anything (at least with the Cobalts) outside of connecting wires from the SPDT on the switch motor to the GND.
I saw Dennis Cherry I think do the SW feed back with a DR4088GND. 👍 @@HumancityJunction