HP Plotter Does Better Than My High End Canon and Epson Printers

[@kian8382]

I bet youtube recommended this because it thinks this is harry potter.

[@astrostar000]

You're a plotter, Harry! Harry Plotter 😂

[@Francois_L_7933]

On my small Deskjet, when I get a blocked print head, I take a plastic plate that I fill with a 50-50 mix of distilled water and 90% Isopropyl and just let the head grid soak for a few hours. It often will just unclog the bad nozzles.

[@FIGITALREVOLUTION]

Yep did that with the old head once and worked fine- this time it was just a bit too much gone

[@chriscard6544]

What do you recommand to print negatives for Palladium in big size ?

[@FIGITALREVOLUTION]

Probably an Epson - maybe running Cone inks as they have a very good setup for that-

[@chriscard6544]

@@FIGITALREVOLUTION thank you so much

[@FIGITALREVOLUTION]

@ you bet!

[@spedi6721]

Why didn't finish the old color tanks first?

[@FIGITALREVOLUTION]

They had been sitting for some time
And wanted a clean install with the new head- also, they were almost empty.

[@spedi6721]

@FIGITALREVOLUTION maybe use them for a colorful experiment?

[@FIGITALREVOLUTION]

@ I sometime open up and use for spotting on prints if their is a paper issue

[@cameraprepper7938]

So is the HP plotter a Tri-X 400 or T-MAX 400 ? I know those Kodak films very well, the T-MAX 400 are superior !

[@FIGITALREVOLUTION]

Somewhere in between- not as smooth as TMAX- but not as course at 400TX