How to Replace Electric Water Pump 2004-2010 BMW X3

Поделиться
HTML-код
  • Опубликовано: 28 авг 2024
  • Buy Now!
    New Engine Water Pump from 1AAuto.com 1aau.to/ia/1AEW...
    This video shows you how to install a TRQ water pump in your 2004-2010 BMW X3.The water pump keeps coolant flowing through your engine. Common failures of the water pump will leave the coolant leaking, or stagnant. Both will lead to overheating if left untreated. Install a new engineered to fit water pump from TRQ for total peace of mind.
    This process should be similar on the following vehicles:
    2004 BMW X3
    2005 BMW X3
    2006 BMW X3
    2007 BMW X3
    2008 BMW X3
    2009 BMW X3
    2010 BMW X3
    Tools you will need:
    • Phillips Head Screwdriver 1aau.to/oc/1AXA...
    • Pry Bar 1aau.to/ob/1AXA...
    • 10mm Socket 1aau.to/od/1AXA...
    • 17mm Socket 1aau.to/ob/1AXA...
    • 6mm Socket 1aau.to/od/1AXA...
    • 8mm Socket 1aau.to/od/1AXA...
    • Trim Tool Set 1aau.to/oc/1AXX...
    • Push Pin Pliers
    • E12 Inverted Torx Socket
    • T25 Socket 1aau.to/ob/1AXA...
    • T30 Socket
    • Ratchet 1aau.to/oc/1AXA...
    • Socket Extensions 1aau.to/ob/1AXA...
    • Torque Wrench 1aau.to/oc/1AXA...
    • Drain Pan 1aau.to/ob/1AXA...
    • Pick 1aau.to/ob/1AXA...
    Subscribe: / @trq
    ⚠ DISCLAIMER:
    While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

Комментарии • 14

  • @TRQ
    @TRQ  2 года назад +2

    √ Watch the Video
    √ Buy The Part at 1A Auto 1aau.to/m/Shop-TRQ-Parts
    √ Do it Yourself
    √ Save Money

  • @walidbast
    @walidbast 7 месяцев назад +1

    Hands down you make some of the best videos. No fluff or lengthy useless introductions. Straight to the point
    Thank you.

    • @TRQ
      @TRQ  7 месяцев назад

      +@walidbast Thank you! We love empowering our customers and showing how to perform DIY auto repairs with our high-quality auto parts. 1aau.to/m/Shop-TRQ

  • @ykmalachi
    @ykmalachi Год назад +11

    Well made video...... but after doing a few of these now.... grossly misleads you into thinking this goes this smooth.

  • @bigmcdee8681
    @bigmcdee8681 3 месяца назад

    I followed these instructions step by step and used almost every tool you used except the pick and power tools but wow this was easy!!!! I encountered no bumps in the road thanks to this video!! You guys are the best!!!

  • @lasomil
    @lasomil Год назад +6

    You have to bleed the cooling system every time after it was drained and refilled.
    It will take 12 minutes so make sure your battery is in good condition and charged.
    Turn ignition ON (do not start engine), set temperature controls in vehicle interior to full warm and blower fan speed to low.
    Press accelerator pedal to floor and hold down for ten seconds. Electric coolant pump will run for about 12 minutes
    (cycling on and off) to circulate coolant and bleed air from cooling system. When bleeding, expect a steady stream to flow from the bleed hole in the reservoir. Once pump has run the cycle, check level of coolant in expansion tank and adjust as needed.
    Start and run engine at idle until it reaches operating temperature and check cooling system for leaks.

  • @deltacharlieecho4732
    @deltacharlieecho4732 Год назад +2

    I am almost positive this only applies to the N52 as the M54 should still have the mechanical fuel pump powered by the serpentine belt. So it definitely isn't for anything earlier than mid 2005 at the VERY earliest.

  • @Basslicks82
    @Basslicks82 Год назад +1

    You actually can get the water pump out of the bottom through the same "hole" that you got the thermostat housing out of. Also, right in front of the swaybar bracket is space that you can slide an extension through, then put your swivel and socket on the end of it and get a better angle to tighten those water pump bolts down.
    Great video though. Thanks for the information.

  • @BrandonSalas-us8mm
    @BrandonSalas-us8mm 5 месяцев назад

    Z where’s my boy verichle at he got the day off friend?

  • @thecharlye1978
    @thecharlye1978 Год назад +2

    Paín on the A. SS change a water pump

  • @diamxxx7550
    @diamxxx7550 6 месяцев назад

    Спасибо бро!!

  • @tracyCasemore
    @tracyCasemore 4 месяца назад

    That was a great video,good job!!

  • @SleepyJoe408
    @SleepyJoe408 11 месяцев назад

    Is the x5 same or atleast similar to the x3?

  • @XTheAwesomerX
    @XTheAwesomerX 9 месяцев назад

    What’s the part number for this?