Honda CR-Z Progress Technology Sway Bar Install and Update

This is an update video where I install the Progress Technology 19mm rear sway bar on the CR-Z. This is pretty straightforward, but installation is slightly different than what the instructions show. It's truly a bolt-on accessory.
Buy the sway bar on KamiSpeed: www.kamispeed....
Clazzio seat covers: www.gotuning.co...
Hood Supports: www.amazon.com...
Thanks for watching! Leave any questions or comments below!

[@DQNguyen91]

my sway bars just came in yesterday. just wanted to say thanks for making this video!

[@VSPEEDGarage]

Best of luck and enjoy!

[@sicwhittlocal209]

did a 1.5 drop and the exhaust bangs the sway bar when there is downward movement, its after marked exhaust so still working on it,

[@CHIBA280CRV]

Fantastic informative video 👍🏼👍🏼👍🏼👍🏼👍🏼

[@sonofnothing]

So, those three holes are already in the stock spring housing?Is there a stock rear sway that you removed, or it's just that simple? I'm about to install the progress sway and K&N typhoon today. Thanks

[@VSPEEDGarage]

Yes, they should all be there on the stock spring mounts. There is no stock sway bar, so nothing to remove.

[@youneedhost]

You need to start taking care of the bottom of your car is getting rust pretty bad.... get some brushes and rust remover and paint that all black

[@VSPEEDGarage]

MR. S1000RR TUBASO it’s too late for that, plus I sold the car. It was well past it’s value to look into doing that but I understand your concern!

[@VSPEEDGarage]

Also I live in upstate NY, Where they salt the roads heavily and to coat on top of that rust would only make the problem worse. It seals in the rust