Chevy stroker 383 Budget Build Finale
HTML-код
- Опубликовано: 21 окт 2024
- In this week's video the Hustle House Performance Automotive crew attempts to install and break in the freshly "re-rebuilt" 383 stroker. In the pilot episode we covered the camshaft failure upon break in of this engine and the crew has been on pins and needles ever since. Episodes 1 and 2 of the 383 stroker series cover clean up and reassembly of this wounded mouse motor. Now that we "Got all that work done" its Judgement Day for this camshaft eating rodent of an engine. Will it drive off into Destany or will it wind up in the scrap pile out back of the shop?!? Tune in to find out on this week's episode of The Hustle House Performance Automotive RUclips Channel.
#chevrolet
#rebuild
#willitrun
#restoration
Please visit our other platforms
/ hustlehousepa68
/ hustlehousepa
www.tiktok.com...
/ rusticowner
Thanks for all your help and support, it means a lot to us.
We appreciate all the subscribing, liking, comments, and sharing.
We wish you all the happiness and health,
God Bless!!
This is so sweet ♡
Thank you we literally didn’t meet the time frame lol but close enough right lol !!! Thank you for watching It means a lot 💜 hope you stick around for the next one ha ha
440 tow rig. Heck Yeah!
hahaha you know how it is.. 10 vehicles sitting around and the only good battery was in the red car sooo. lol. Thanks for watching
lol i know how that is for sure I use my LS Swapped BMW as a tow rig all the time because i dont want to open the gate to bring my truck in the back yard lol@@HustlehousePA1978
lol see there! Thats if theres any tires left on it. That beemer burns them pretty good. hey I saw that Javelin, pretty sure you'd get all kinda views on that thing doin a budget build. It would look pretty tough with some fattys on it. Make some good lookin thumbnails.
@@HustlehousePA1978 there is a part of me that wants to put the bigs and littles from the nova on there and make the drivetrain too lol I would think getting that AMC 290 tuned up would be way more expensive than the old SBC.
yea your right there, not a cheap way to be had now. old 290 with a couple ebay turbos lol
Pull the gear off a old distributor for a oil primer just drop it in and spin it not to drop or try and keep lined up
Hey whats up? Yea saw that hack a while back but don't have much of the Chevrolet stuff on hand or we woulda cut one up. It don't show in the video but it probably took me 20 minutes to prime that thing each time. Hard to hold that screwdriver on the oil pump any amount of time, not to mention the paranoia of dropping it down into no mans land. but hey, we do tend to do everything the hard way! Well we sure appreciate the comment and as always we appreciate ya watchin. Happy Holidays!
😂
I smiling cause it’s over 👍🏻👍🏻😂