STANLEY D-1610 Door Closer Parallel Arm Installation

The D-1610 Series is a slim line closer uniquely designed to accommodate the standard aluminum storefront application foot print. This video outlines how to install it in a parallel arm configuration.
For more information, please visit www.stanleyhardwarefordoors.com.

[@toddavis8603]

Great pre-load explaination.Overall A+

[@nikhilmandhare3080]

Thanks for Sharing this Information.. Nice Work Keep it Up.

[@albertmichaelson6779]

Just curious why you didn't put the door closure or the old one was on the door frame? Tap the existing holes. That way you don't have for big holes in the door frame.

[@trevormcmanis]

Thank you for sharing this video. I was under the understanding that the "adjustment screws " should face the hinges. I see that is not the case in your application. Can you explain? Thank you in advance for your help

[@alamgeer2005]

no mention of the template

[@AMIR-nm7fo]

why didn't you show how to take the measurements for installation ? inches from the door frame etc.

[@CC-ls8uf]

Most closers will come with templates

[@jamesgonzalez3296]

So I installed an arm and the screw that connects the “joints” of the arm keeps scraping the top “lip” of the door frame. Does anyone know how to fix this without cutting a hole through the lip?

[@kellyslingerland6611]

I suspect you measured down from the frame rather than the stop, or "lip" you mention. That positions the whole closer too high on the door, causing the screw to scrape

[@shaneraines2094]

Arm installation thats about it no refrence to how and why or dimensions next video how to use a paint brush! shocking

[@brijmohanthakur7521]

That's arm shouldn't be touching door

[@albertmichaelson6779]

And he should have put it on the door frame to hide the existing holes. Guys like us have to comment of course.

[@hotrodnashes4342]

That whole video is trash needs to be taken down.