It would be nice to change my flat tire but I can’t cuse the fucking bolt is stuck and won’t come off used an impact drill nd all still can’t get it off been over 3 months ..
😅😅First of all this is supposed to be motor change! Why mention motor change when you are only changing tyre? Secondly the worst part is you have installed the tyre wrong way! The tyre has a mark on it which points to front rotation and also a red line which is supposed to be on the left side as in the front.You are misleading other people which could be dangerous so before posting this video on you tube you better be sure of the procedure.
Question. Not regarding the motor but the tyres. It says inflate to 50 PSI. But when I do this and unscrew the air compressor some air leaks out during that process. And the PSI is 40. So, is it safe to inflate to 55 PSI or 60? That way, when I detach the air compressor, it will release some air and drop down to 50 PSI. Or would anything above 50 PSI burst the inner tube? 😂
Hi there, the general recommendation is 30psi-36psi (2.07 bar-2.5 bar), which can be adjusted by the customer for different usage conditions. For softer ground, you can lower the tire pressure a little. On hard ground, you can increase the pressure a little. If the ambient temperature is high, you can also lower the pressure a little.
Cuantos libras de aire se le ponen a esas llantas
It would be nice to change my flat tire but I can’t cuse the fucking bolt is stuck and won’t come off used an impact drill nd all still can’t get it off been over 3 months ..
Tire change and motor change are very different procedures........
😅😅First of all this is supposed to be motor change! Why mention motor change when you are only changing tyre? Secondly the worst part is you have installed the tyre wrong way! The tyre has a mark on it which points to front rotation and also a red line which is supposed to be on the left side as in the front.You are misleading other people which could be dangerous so before posting this video on you tube you better be sure of the procedure.
Question. Not regarding the motor but the tyres. It says inflate to 50 PSI. But when I do this and unscrew the air compressor some air leaks out during that process. And the PSI is 40. So, is it safe to inflate to 55 PSI or 60? That way, when I detach the air compressor, it will release some air and drop down to 50 PSI. Or would anything above 50 PSI burst the inner tube? 😂
Hi there, the general recommendation is 30psi-36psi (2.07 bar-2.5 bar), which can be adjusted by the customer for different usage conditions.
For softer ground, you can lower the tire pressure a little.
On hard ground, you can increase the pressure a little.
If the ambient temperature is high, you can also lower the pressure a little.
a question I have a problem with my scooter I have e6 code what can I do?
The E6 code means your scooter is with low voltage protection and need to charge.